Pro-Ject Speaker Box 3 E Carbon Instructions

Table of Contents

Q: What should I do if I encounter a problem with the speaker?
- A: If you cannot resolve the issue, contact your dealer for assistance. If needed, the unit should be sent to the distributor in your country.
Q: Can I use the speaker in wet locations?
- A: No, the product should not be used in damp or wet locations.
Q: Can I modify any part of the product?
- A: Modifying the product by unauthorized persons releases the manufacturer from liability. Stick to the provided instructions for safe usage.

Dear music lover, thank you for purchasing a speaker from Pro-Ject Audio Systems.
To achieve maximum performance and reliability you should study these instructions for use carefully.
Warning of a hazard for the user, the unit, or possible misuse. Important notice.

Avoid spilling liquids on the speaker, connection terminal, or speaker cable.
Never place any item containing liquid, such as a flower vase on or near the device.
Never place any naked flame sources, such as lighted candles on or near the speakers.
The product shall not be used in damp or wet locations, next to a bathtub, sink, swimming pool, or any other similar conditions.

Loudspeaker positioning

Ideally, the loudspeakers should be positioned at least 60 cm away from walls and 1,8 meters apart.
The space between the two loudspeakers and the distance to the listeners are important.
If loudspeakers are placed too close together or too far apart, stereo images will not be fully developed.
In average living rooms, speaker spacing between 2 and 4 meters will usually produce satisfactory results.
The listener’s distance to the loudspeakers should be equal to the distance between the loudspeakers (equilateral triangle).
The height is also an important factor. The tweeter of the speaker should be at the same height as your ears.
If you have the space, we always recommend using speaker stands. If not, we recommend using “Damp it” underneath your speakers.
It decouples the speaker from the surface of the furniture, and you can also slightly adjust the height of the speaker.
Angle your speakers inward, so the drivers directly point to your ears. Toeing in the speakers helps with the perception of the stereo image.
You can decrease the toe-in angle to create a wider stereo image. Experiment to find your sweet spot!

Amplifier capacity – power handling

Your loudspeaker system will operate satisfactorily with any good amplifier designed for use with a 4-8 Ohm impedance load.
Although loudspeakers are designed to handle high-power loadings, you must remember that any loudspeaker that is abused with excessive use of volume, tone controls, and graphic equalizers is likely to cause damage to the drive units.
Be careful especially with small amplifiers constantly driven on high power levels as these may be liable to go into „clipping mode“ and distort the signal causing possible damage.
If you hear a distorted signal through the loudspeakers, you must reduce the power level.

We strongly recommend the use of high-quality speaker cables, color-coded or grooved cables are recommended to assist in checking polarity, your local dealer should be able to advise you on this point.
Always switch OFF your amplifier before making any connections or adjustments to the system.
Wire the right-hand channel cable so that the positive (RED) terminal of your loudspeaker is connected to the positive (RED) on your amplifier, and the negative (BLACK) terminal of your loudspeaker is connected to the negative (BLACK) terminal on your amplifier.
Repeat the instructions for the left-hand channel. Do NOT connect more than one loudspeaker to one terminal on your amplifier.
Set the volume level to a minimum before switching on the amplifier!

Speaker Grills

We recommend operating the speakers without grills, as the delicate treble can spread freely.
Our almost acoustically transparent speaker grilles only serve as protection against outer influences (e.g. pets).

Wall mount

Wall mount brackets are available separately. Please contact your dealer for further information.

Technical specifications Speaker Box 3E

Service

Should you encounter a problem that you are not able to alleviate or identify despite the above information, please contact your dealer for further advice.
Only if the problem cannot be resolved there, the unit should be sent to the responsible distributor in your country.

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions for use.
Modification or changes to any part of the product by unauthorized persons release the manufacturer from any liability over and above the lawful rights of the customer.

Copyright, trademarks

Pro-Ject Audio Systems is a registered Trademark of H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems Copyright © 2024. All rights reserved.
The information was correct at the time of going to press. The manufacturer reserves the right to make changes to the technical specification without prior notice as deemed necessary to uphold the ongoing process of technical development.
Waste from Electrical and Electronic Equipment (WEEE): This directive mandates the collection and recycling of electronics and component materials to reduce the amount going to landfills.
Outside North America, when the user decides to discard this product, it must be sent to a separate collection facility for recycling. Please contact your point of purchase for more details.
©Pro-Ject Audio Systems · Speaker Box 3E · Revision 2024.01.09