BEAUTURAL 719NA-0001 Fabric Shaver Instruction Manual
- August 20, 2024
- BEAUTURAL
Table of Contents
BEAUTURAL 719NA-0001 Fabric Shaver
Product Information
Specifications
| Power Supply | 2 x 1.5V type AA batteries |
|---|---|
| Voltage | 3V |
Appliance Description
- ON/OFF/Speed Switch
- Battery Compartment Cover
- Fluff Collector
- Cutting Blades
- Shaver Foil
- Adjustable Spacer
- Cleaning Brush
- Protection Cap
Product Usage Instructions
Intended Use
This product is only authorized for domestic use and not for commercial or
industrial purposes. It is only intended for applications described in these
instructions.
Safety Information
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
- Use ONLY the type of battery as indicated in the “Specifications” section of this manual.
- Do not throw the batteries into fire. Do not recharge the batteries to avoid explosion.
- Always keep batteries out of the reach of infants and young children to prevent them from being swallowed. If swallowed, take immediate action and contact medical authorities for help.
Before using the fabric shaver for the first time, check the package contents to ensure all parts are free of visible damage.
Removing/Attaching the Spacer
- To remove the spacer, hold the shaver with one hand, grab the spacer, put your thumb on the edge of the spacer, pull the spacer forward, and remove it.
- To attach the spacer, place it on the cutting head and press it firmly. Make sure the two small tabs on the spacer grip into the two recesses on the shaver.
Warning: Keep the protective cap in place when the shaver is not in use to prevent children from accidentally injuring themselves.
Emptying the Fluff Collector
- Pull the fluff collector a little way down and lift it off.
- Empty the textile fluff.
- Place the fluff collector back on the shaver.
Introduction
Thank you for purchasing the beautiful fabric Shaver. This instruction manual contains important information about safety, usage, and disposal. Use the product as described and keep this manual for future reference. If you sell this shaver or pass it on, also give this manual to the new owner.
Appliance Description
- ON/OFF/Speed Switch
- Battery Compartment Cover W
- Fluff Collector
- Cutting Blades
- Shaver Foil
- Adjustable Spacer
- Cleaning Brush
- Protection Cap
Safety Instructions
Intended Use
This product is only authorized for domestic use and not for commercial or industrial purposes. It is only intended for applications described in these instructions.
Safety Information
- This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
- Cleaning and user maintenance shall not be made by children without supervision.
- Do not expose or submerge the shaver in water. Do not use the fabric shaver on moist fabrics.
- Make sure no foreign objects penetrate the shaver.
- Do not attempt to open the shaver’s housing, except the battery compartment to replace batteries and shaver foil to clean cutting blades.
- Do not oil or grease the cutting blades! This will smear your clothes.
- Remove the batteries if you do not intend to use the shaver for a long period of time.
- If the batteries leak, remove them immediately and clean the battery compartment with a dry cloth.
- Use ONLY the type of battery as indicated in the “Specifications” section of this manual.
- Do not throw the batteries into fire. Do not recharge the batteries to avoid explosion. o
- Always keep batteries out of the reach of infants and young children to prevent them from being swallowed. If swallowed, take immediate action and contact medical authorities for help.
Included Items
- 1x Fabric Shaver
- 1x Protection Cap
- 2 x Replaceable Cutting Blades
- 1x Cleaning Brush
- 1 x Instructional Manual
Before using the fabric shaver for the first time, check the package contents to ensure all parts are free of visible damage.
Handling and Operation
Inserting Batteries
- Press the tabs on the battery compartment cover and push down.
- Insert 2 AA batteries (not included), paying attention to the polarity.
- Put the battery compartment cover back on and the shaver will be ready for use.
Testing
- The fabric shaver can damage delicate fabrics and very soft materials such as angora. Before removing fluff, always test on a small area of the fabric that is not publicly visible to confirm the speed level isappropriate for the fabric.
- Turn the transparent adjustable spacer to the level “Thick” and then push the On/Off/Speed Switch to Speed Level 1. To test the most suitable speed for your fabrics and avoid damaging the garment, it is recommended to use Speed Level 1 first, then switch up to Speed Level 2.
Shaving Off Fluff
- Put the garment on a flat surface, such as an ironing board. Make sure the surface has no wrinkles. Otherwise, the garment may be damaged.
- Turn the spacer to the desired level or remove it completely (see the “Removing/Attaching the Spacer” section of this manual).
- “Thick” is for large bobbles and coarse textiles; 5mm- length distance from the cutting blades.
- “Thin” is for small lint/bobbles and fine textiles; 3mm- length distance from the cutting blades.
- Removing the spacer is only for very fine lint; virtually no spacing to the cutting blades.
- Push the On/Off/Speed Switch to the required speed level.
- Guide the shaver foil lightly over the material. The fluff and bobbles will be shaved off and collected in the fluff collector.
- To turn off the shaver, push the On/Off/Speed Switch back to Speed Level 0.
Note: Empty the fluff collector regularly. The fluff collector should never be more than 3/4 full. An overfilled fluff collector will slow the cutting blades no matter the amount of battery power left.
Removing/Attaching the Spacer
- To remove the spacer, hold the shaver with one hand, grab the spacer, put your thumb on the edge of the spacer, pull the spacer forward, and remove it.
- To attach the spacer, place it on the cutting head and press it firmly. Make sure the two small tabs on the spacer grip into the two recesses on the shaver.
- To protect the shaver foil, you should remove the spacer and place the protective cap on the shaver foil when not using the fabric shaver
Replacing the Cutting Blades
-
To remove the cutting blades
Unscrew the shaver foil, carefully grasp the cutting blades’ edge and pull them out, avoiding damage to the blades. -
To attach the cutting blades
Grasp the cutting blades’ edge and firmly insert the cutting blades into shaver body. Finally, screw the shaver foil back into place.
Warning : Keep the protective cap in place when the shaver is not in use to prevent children from accidentally injuring themselves.
Emptying the Fluff Collector
- Pull the fluff collector a little way down and lift it off.
- Empty the textile fluff.
- Place the fluff collector back on the shaver.
Cleaning the Housing and Cutting Blades
- Unscrew the shaver foil, spacer, and protective cap, cleaning those parts with a slightly damp cloth.
- Use the officially provided cleaning brush to remove fluff and lint remnants from the cutting blades.
- Screw the shaver foil back on when all parts are completely dry.
- Place the spacer back on the shaver:
Note:
- Never use any corrosive liquids. These may damage the surface of the shaver.
- Be careful when handling the cutting blades. They are very sharp and can easily be damaged.
Specifications
- Power Supply : 2 x 1.5V type AA batteries
- Voltage : 3V ==
DISPOSAL
Disposal of the appliance
Under no circumstances should you dispose of the appliance in normal domestic
waste. This product is subject to the provisions of European Directive
2012/19/EU. Dispose of the appliance via an approved disposal company or your
municipal waste facility. Please observe currently applicable regulations.
Please contact your waste disposal center if you need any further information.
Disposal of batteries
- Used batteries may not be disposed of in household waste.
- All consumers are statutorily required to dispose of batteries at a collection point provided by their local municipality or retail store. The purpose of thisobligation is to ensure batteries are disposed of in a non-polluting manner. Only dispose of batteries when they are fully discharged
- The appliance’s packaging is made from environmentally friendly material and can be disposed of at your local recycling plant.
Customer Service
UNITED STATES CANADA UNITED KINGDOM GERMANY/FRANCE ITALY/SPAIN
Phone : +1909-391-3888 (Mon-Fri 9:00 am – 5:00 pm PST)
Email : ushelp@1byonebros.com
Email : cahelp@1byonebros.com
Phone : +44 158 241 2681 (Mon-Fri 9:00 am – 6:00 pm UTC)
Email : ukhelp@1byonebros.com
Email : euhelp@1byonebros.com
BRAND OWNER N. 1 bY” 1byone Products Inc. 1230 E Belmont Street, Ontario, CA, USA 91761 Customer Service : +1 909-391-3888 www.1byonebros.com
EUROPEAN REPRESENTATIVE(IMPORTER)
APEX CE SPECIALISTS LIMITED Unit 3d North Point House, North Point Business
Park, New Mallow Road, Cork, 123 AT2P, Ireland hros.com
BRITISH REPRESENTATIVE(IMPORTER)
APEX CE SPECIALISTS LIMITED 89 Princess Street, Manchester, M1 4HT, UK
FAQ’s
Can I use the fabric shaver on moist fabrics?
No, do not use the fabric shaver on moist fabrics.
What type of batteries should I use?
How often should I empty the fluff collector?
Empty the fluff collector regularly. The fluff collector should never be more than 3/4 full.
Can children use the fabric shaver?
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
How do I clean the cutting blades?
Use the officially provided cleaning brush to remove fluff and lint remnants from the cutting blades. Never use any corrosive liquids.