DAWWEE YY2835 Smart Fairy String Lights Remote Control Instructions
- August 17, 2024
- DAWWEE
Table of Contents
DAWWEE YY2835 Smart Fairy String Lights Remote Control
Product Information
Specifications:
- Functions: Speed/Brightness, Sensitivity, Static colors switch, Overlay, 7 colors flow gradually, Music Mode, Loop mode, Fading out, Delay off, Built-in mode switch, DIY Mode, Lighting effects
- Color Options: Static RGB, 7 static colors, 3 static colors switch
- Modes: Jump, Breathing, Strobe, Running Water
Product Usage Instructions
Function Control:
Use the remote control to adjust speed, brightness, sensitivity, and switch
between static colors. You can also set overlay modes and choose from
different color flows.
Static Colors Switch:
Switch between static RGB colors and 7 static colors using the designated
buttons on the remote control.
Overlay Modes:
Select from various overlay modes such as flowing gradually or overlaying
colors from both sides to the middle.
Loop Mode:
Activate loop mode to have the colors run circularly or fade out in a
specific direction.
Delay Off:
You can set the product to turn off automatically after 1 hour or 30
minutes of inactivity.
Built-in and DIY Modes:
Explore different built-in modes by switching between them or customize
your own DIY modes with unique lighting effects.
Lighting Effects:
Enjoy 4 different lighting effects that sync with external music rhythms
for an enhanced visual experience.
FAQ
-
How do I match the remote control code?
To match the remote control code, power on the device and hold down the ON key for 5 seconds. The device will flash slowly to indicate successful code matching. -
How do I clear the remote control code?
To clear the remote control code, power on the device and hold down the OFF key for 5 seconds. The device will flash quickly to indicate successful clearing of the code. -
Can I record custom colors in Scene mode?
Scene mode can only record one custom color at a time.
Ｋey Functions
Note:
- Remote control code matching: power on the device, hold down “ON” key for 5 seconds, the device flashes slowly to indicate successful code matching.
- Remote code clearing: power on the device, hold down “OFF” key for 5 seconds, the device flashes quickly to indicate successful clearing
- Scene mode can only record one custom color.
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The
device can be used in portable exposure condition without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>