FREE THE TONE RJ-2V Red Jasper Low Gain Drive Pedal User Guide
- June 3, 2024
- FREE THE TONE
Table of Contents
RED JASPER/RJ-2V
User’s Guide
RJ-2V Red Jasper Low Gain Drive Pedal
Thank you for choosing a Free The Tone product. Please read this user’s manual thoroughly to ensure that you’ll benefit fully from the advanced features, performance, and reliability your Free The Tone product is designed to provide.
About the Product
The Free The Tone RED JASPER (RJ-2V) is a low gain overdrive that can provide
sensitivity and responsive tone plus a natural and comfortable compression
feel usually obtainable only from a good tube amplifier. The RED JASPER is
very versatile and can be used not just for creating a good comping sound, but
also, for example, for adding the RED JASPER sound to a clean sound, making
your guitar tone stand out from the band, or it can be used as a booster.
The RJ-2V has two internal switches to select low-end frequency
characteristics for lower register sound adjustment. You can select one from
four modes that have different low-end frequency characteristics.
From setting A to setting D, the cut-off of the bass range’s low-end is
gradually stronger.
Setting A SW1: ON / SW2: ON
Setting B SW1: ON / SW2: OFF
Setting C SW1: OFF / SW2: ON （※initial setting at shipment from factory）
Setting D SW1: OFF / SW2: OFF
The RED JASPER is also equipped with Free The Tone’s original HTS (Holistic
Tonal Solution) circuit that protects the bypassed guitar signal from becoming
too thin or losing tonality.
The LED indicator on this unit functions not only to show the effect on/off
status but also to monitor the battery voltage. When the voltage becomes lower
than about 6 V, the LED starts to dim. Although effect sound is still
available in this state, we recommend to exchange the battery with a new one
to keep full performance of this product.
Precautions
Inserting or removing a plug from the input jack while the unit’s output is connected to an amplifier/speakers that is turned on can cause noise that can damage the speakers. If the unit mal-functions or behaves abnormally, cease operation immediately and refer the problem to the supplier. If the unit will not be used for an extended period of time, remove the battery to prevent damage due to chemical leakage from the battery. When the battery voltage drops too low for proper operation the effect sound may become weak, the output level may drop, or no output will be produced at all. Be sure to replace the battery as soon as possible if such symptoms occur.
Main Specification
- Input Impedance: 390kΩ
- Output Load Impedance: min. 10kΩ
- Controls: DRIVE, HI-CUT, LEVEL
- Terminals: 1/4″ standard phone jack (input, output), 9 VDC input jack (socket for AC adapter)
- Power Source: 1 x 9 V battery, AC adapter
- Current Consumption: 9 VDC, 11 mA
- Dimensions (D x W x H, incl. protrusions such as foot switch, jack, etc.) : 123 x 100 x 53 mm (4.84 x 3.94 x 2.09 in)
- Weight (excl. battery): approx. 320 g
- Accessories: Warranty card, User’s guide, 4 x Rubber feet
Specifications and appearance are subject to change for improvement without prior notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>