ROCKVILLE RWB80B Marine Wakeboard Tower Speakers Instruction Manual
- August 12, 2024
- RockVille
Table of Contents
ROCKVILLE RWB80B Marine Wakeboard Tower Speakers
Introduction
RWB65/RWBBO
- Thank you for purchasing these Rockville RWB Series 2-Way Wakeboard Tower Speakers.
- Please read this guide carefully for proper installation of your RWB Series Speakers. Should you need technical assistance please call our technical helpline at 1-646-758-0144, Monday through Thursday, 9 am to 10 pm EST., and Fridays, 9 am to 3 pm EST.
- Go to vimeo.com/222473581 or scan the QR code and watch a short video, which shows you how to set this item up and how to use it.
Mounting Bracket
Speaker Configuration
Mounting Instructions
- Release the rear clamp piece by using an alien wrench to remove the screws.
- Place the front clamp piece snug against the crossbar.
- Place the rear clamp piece on the other side of the crossbar.
- Insert and tighten screws ensuring a tight, snug fit.
- Most speaker damage is caused by amplifiers with too much power (wattage).
- The proper way to set your gain is to turn your receiver volume to 75% of the max, and then slowly turn your gain up. The second you hear any slight distortion, turn it down one notch and leave it at that setting. Amps are not meant to be played with the gain up to the max. If this is the case, lower your gain slowly until you hear the amplifier stop clipping.
© 2021 ROCKVILLE// Features and specifications are subject to change and/or improvement without notice RockvilleAudio.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>