Generic S2S Unmanned Aerial Vehicle (UAV) Instruction Manual
- August 12, 2024
- Generic
Table of Contents
MANUAL
Please keep the manual for routine maintenance!
Remote control batteries installation
Open and remove the battery cover, according to the correct polarity pulting into
Remote Control
Functions Instructions
- One key rolling
- Headless mode
- One key take-off /One key landing
- Speed
- Power switch
- Lens upward fine-uning
- Lens downward fine-luning
- Photo/Video
- Obstacle Avoidance
- Up&dowr/Tum let & right
- Forward & backward/Left & right
Preparing for flight
Preparing Inspection
Please inspect the following items before flying
- Whether the drone and remote control are both with fully battery power
- Whether the propellers are installed correctly and without any damage
- Whether the propellers can ran normally when the produce is started
- Check whether the gyroscope completed successfully.
- Whether successful connect smart phone and have transmission image
- Whether environment suitable for flying
Notes: Please check drone’ams are fully open.
Flight environment requirements
Indoor flying: please choose the open spaces that no obstacles, people and pets Outdoor flying: Please choose sunny, windless or breezy weather. Keep the aircraft within your sight when flying, away from obstacles, high-voltage lines, trees, etc. Do not fly when there is strong wind, heavy rain etc. weather.
First Using
Calibration
Turn on the power switch and place the aircraft an the flat ground with the indicator fleshes. And then turn on the power switch of the remote control and the aircraft will automatically matching the frequency. After, pulling out the two rockers to connect the gyroscope with a sound of Di and the aircraft indicator’s light is on for a long time, which means that the frequency matching is completed and the aircraft can be taken off.
Note that the gyroscope needs to be calibrated every time the flight is restarted and the aircraft needs to be placed horizontally on the ground.
Advanced Flight Function
Speed Adjustment
Press the speed switch button on the remote control to switch the flight speed of the aircraft. When switching to the medium speed gear, the remote control deliver two sounds of Di. When switching to the high gear, the remote control will deliver three sounds of Di. Each time the remote control and the aircraft are turned off and restarted, the aircraft gear will automatically return to the low gear.
Headless mode
Press headless mode button, start Headless mode, press again exit this mode.
Camera Adjustment
The drone camera up or down adjustment.
Rolling
Press the rolling button and then push the direction control lever to roll the aircraft in different directions.
Warning: ruling functian consumes a lbtaf power and should be reduced. More important ,the nowise suggests using it in an open apace.(When the battery is fully charged, the ruling time is about 10 minutes. And the functions temporarily suspended during the remaining battery time, while the other functions are normally.)
Photo/Video
After turn on the aircraft, press the Photo/Video button to take photos and record video.
Obstacle Ayoidance
After turning on the aircraft press the obstacle avoidance mode button. At this time if the steering rod is tuned in any direction, the obstacle avoidance head of the aircraft will automatically sense whether there is an obstacle in that direction. If there is, the aircraft will not be able to fly in that direction.
Basic operation
REMOTE CONTROL| DRONE|
FLOW
---|---|---
|
Fly downward
|
Push left control lever forward the drone ascends vertically Pull left control lever rearward, the drone descends vertically.
|
Spin anticlockwise
|
Push left control lever rightward the drone spins dock wise. Push left control lever left ward, the drone spins anticlockwise
|
Pitch backward
|
Push right control lever forward the drone pitches forward.Pul ight control lever rearward,the drone pitches backward
|
Roll leftward Roll nghtward
|
Push right control lever rightward the drone rols rightward.Push right control lever leftward,the drone rolls leftward.
---|---|---
FCC STATEMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.