XTREME XWCB-1040-WHT Smart Watch Charger Instruction Manual

: August 3, 2024
: Xtreme

Table of Contents

XTREME XWCB-1040-WHT Smart Watch Charger
PRODUCT INTRODUCTION
SAFETY AND CARE INFORMATION
SPECIFICATIONS
USING YOUR SMART WATCH CHARGER
ONE YEAR WARRANTY
FCC STATEMENT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

XTREME XWCB-1040-WHT Smart Watch Charger

PRODUCT INTRODUCTION

Our watch charger is compatible with Apple Watch® series 1/2/3/4/5/6/7/8/9/Ultra 2/SE (38mm 40mm 42mm 44mm)

SAFETY AND CARE INFORMATION

Failure to follow these safety instructions can lead to fire, electrical shock, personal injury, property damage, or damage to this unit. Make sure to read this entire manual before initial use

Remove cases with any metal components before charging and ensure that no foreign objects, such as metal, are on the charger before it is used.
Avoid prolonged contact with skin when the charger is connected to a power source. Be extra cautious if you have a condition that affects your ability to detect heat. The product can heat up during charging.
Keep in a well-ventilated place when plugged in and charging. Do not place the charger on your body or on or under materials such as a blanket or pillow during charging.
Do not disassemble, crush, or puncture the product.
Do not operate if damaged.
Do not be exposed to water or other liquids.
Keep away from small children or those that require supervision.

WHAT’S INSIDE

6ft Smart Watch Charger
USB-C Adapter
Manual

SPECIFICATIONS

Input: 5V
Cord Length: 6 feet

USING YOUR SMART WATCH CHARGER

Use the USB-A connector (or fit the included USB-C adapter over the USB-A connector) to connect to a 5V USB power adapter (not included) or any other 5V USB power source.
Place the back of your Apple Watch® on the charging side of the charging puck and ensure that it is magnet-locked in place.
Battery icon displays on the screen indicating charging status.
To separate the phone from the charger, simply pull the magnetic puck away from the back of the watch. If you use a protective case that covers the back of the watch or would otherwise obstruct a good connection and charge, remove it before charging. There should be no obstruction between the back of the watch and the charging puck.

Note: The smartwatch charger is larger than the Apple” original. It will not fit in an Apple® charging dock.

ONE YEAR WARRANTY

Xtreme warrants its products for one year against defects in manufacturing under regular consumer use with the original receipt of retail purchase. We believe in our products and want to provide you with a replacement if needed, but we have to know about the problem while the product is still under warranty. If you discover a defect covered by this warranty, please contact us about receiving a replacement. To use the product’s warranty the customer must provide proof of the retailer’s receipt. *Any customers outside of the U.S. will be responsible for shipping and handling charges if a replacement is required that is not due to a manufacturing defect. If there is not a manufacturing defect, shipping and handling will be applied. Xtreme’s warranty is limited to our products only. Our warranty does not cover the replacement or repair cost of any third-party accessory, electronic device, or personal property. For instructions about how to obtain warranty service for your product, please contact Customer

Service: customerservice@xtremecables.com Content is subject to change without prior notice. Some content may differ from how the product works with your specific device.

FCC STATEMENT

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help

RF Exposure Compliance
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.