Nox Xtreme HUMMER VISION Hummer Vision White Installation Guide
- June 1, 2024
- Nox Xtreme
Table of Contents
INSTALLATION
GUIDE
HUMMER VISION Hummer Vision White
CHASSIS DISASSEMBLY
Side panel removal: Unscrew the two side panel screws from the rear panel and
remove the two side panels.
POWER SUPPLY INSTALLATION
Put the power supply into the power supply compartment and secure the power
supply with the power supply screws from the rear panel.
FAN INSTALLATION
Align the fan with the screw holes and lock the fan screws from the outside to
secure the fan.
Fix the power supply compartment fan with screws from above (use long fan
screws to fix it).
3.5”° HDD AND 2.5”’ SSD INSTALLATION
Motherboard SSD hard drive installation
Align the hard drive to the hard drive hole and lock the motherboard screws
from the back to secure the hard drive.
Baseboard hard drive rack HDD+SSD installation
Unscrew the screws and remove the hard drive bracket from the base plate,
align the hard drive with the holes in the hard drive bracket and lock it.
Secure the hard drive with screws and lock the hard drive rack back into the
chassis.
MOTHERBOARD INSTALLATION
Insert the I/O cover into the I/O port, place the motherboard into alignment
with the holes, and lock the motherboard screws to secure the motherboard.
GRAPHIC CARD INSTALLATION
Remove the corresponding PCI card slot, put the graphics card into the hole,
and lock the power screw to secure the graphics card.
USB 2.0 INSTALLATION
Insert the USB 2.0 into the corresponding connector.| USB 3.0
INSTALLATION
Insert the USB 3.0 chassis into the corresponding connector.| HD AUDIO
INSTALLATION
Insert HD Audio into the corresponding connector.
---|---|---
| |
- Plug the hard drive indicator light on the motherboard labeled with “HDD LED”, “HD LED”, “HLED”, or “IED LED”.
- Plug the power indicator light onto the motherboard labeled “PWR LED” or similar.
- Plug in the reset button on the motherboard labeled “RST SW”, “RES SW”, or “RST”.
- Plug the power button on the motherboard labeled “PWP SW”, “PWR BTN”, or “RWR”.
Note: positive to positive, negative to negative. Don’t put it backwards.
STATEMENT OF COMPLIANCE WITH EUROPEAN UNION DIRECTIVES
Nox declares that this product is in compliance with the essential
requirements and other relevant provisions from the following Directives:
2014/30/EU; 2014/35/EU; 2011/65/EU, as applicable. The technical documentation
required by the Conformity Evaluation process is in Nox’s possession and can
be requested through infofanox-xtreme.com.
DISPOSAL OF BATTERIES AND ELECTRICAL OR ELECTRONIC EQUIPMENT WASTE
The existence of this symbol on the product, batteries or respective
packaging, signifies that this product and the contained batteries can not be
disposed as domestic waste. It is the user s responsibility to deliver this
product at a batteries, electrical or electronic recycling pick-up point. The
pick-up and separate recycling contributes for the preservation of natural
resources and suppresses potential negative consequences for the human health
and the environment resultant of inadequate disposal of dangerous substances
contained in batteries and electrical or electronic equipment. For additional
information regarding batteries, electrical or electronic recycling pick-up
points, please contact your local municipal services.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>