NORTHWEST MERV 8 Vent Filters Instructions

Table of Contents

Installation Options #1:

Lift your vent register from the floor, wall, or ceiling.
Clean the register thoroughly.
With the Vent Register face up, push the filter through an end slot on one side. Insert the filter so the BLUE side is facing the air EXIT side and the White side is where the air enters.
Flip the register over.
Rotate open the grates. Reach through the grates, grab the filter, and pull it all the way down to the end of the register.
Even out the remaining portion of the filter so it seats evenly inside the vent register.

Pro Tips! – Add a few drops of your favorite scented oils to your Vent Filters for a pleasant-smelling filtration experience!

Air Filtration Cut to Fit

Measure the opening of the vent register or intake register you want to filter.
Transfer those measurements to the filter using a marker or pen.
Cut the filter according to the measurements.
Wash the register to ensure long-lasting adhesion.
Apply adhesive Velcro dots in the corners and middle of the register.
Press the filter material firmly on the Velcro dots and rub it slightly back and forth to secure it in place. Make sure BLUE is facing the air EXIT side and the White side is where the air enters.
Replace the filter every 30-60 days or when it appears dirty.

Pro Tips! – Enhance your filtration experience by adding a few drops of scented oils to your Vent Filters!

Lift your vent register from the floor, wall, or ceiling.
Second, clean the register.
Third, Flip the register over and rotate the grates 45 degrees.
Slide the filter in through the grates. Insert the filter so the BLUE is the air EXIT side and the White side is where the air enters Then, push the filter into the remainder of the register until it sits flat between the angle grates and the top of the register.
Return the vent register back in its place.
Replace every 30-60 days or when the filter looks dirty.

INSTALLATION OPTIONS #2

Lift your vent register from the floor, wall, or ceiling.
Clean the register.
With the Vent Register face up, push the filter through an end slot on one side. Insert the filter so the BLUE is the air EXIT side and the White side is where the air enters
Flip the register over.
Rotate open the grates. Then, reach through the grates, grab the filter, and pull the filter all the way down to the end of the register.
Sixth, even out the remaining portion of the filter so it seats evenly inside the vent register.

Pro Tips! – Add some drops of your favorite smelling oils to your Vent Filters for great-smelling filtration!

AIR FILTRATION CUT TO FIT:

Measure the opening of the vent register or intake register you want to filter.
Transpose of those measurements to the filter using a marker or pen.
Cut the filter.
Wash the register to ensure long-lasting adhesion.
Apply adhesive Velcro dots in the corners and middle of the register.
After applying the dots to the surface, press the filter material firmly on the Velcro dots and rub the filter slightly back and forth. This will ensure the filter stays in place. Insert the filter so the BLUE is the air EXIT side and the White side is where the air enters
Replace every 30-60 days or when the filter starts to look dirty.
Pro Tips! – Add some drops of your favorite smelling oils to your Vent Filters for great-smelling filtration!

Q: How often should I replace the Vent Filters?
- A: It is recommended to replace the Vent Filters every 30-60 days or when they start to look dirty to maintain optimal air quality.
Q: Can I use scented oils on the Vent Filters?
- A: Yes, you can add a few drops of your favorite scented oils to the Vent Filters for a pleasant-smelling filtration experience. However, ensure that the oils do not cause any allergic reactions or damage to the filter material.