NORTHWEST ENTERPRISES 6 X 16.5 Inch RV AC Filter Replacement Instruction Manual
- September 4, 2024
- NORTHWEST ENTERPRISES
Table of Contents
NORTHWEST ENTERPRISES 6 X 16.5 Inch RV AC Filter Replacement
INSTALLATION OPTIONS #1
Face the filter so the air enters the white side and exits the blue side. The air should enter the white side of the filter and exit the blue side of the material. If using this for floor vent filters the blue side should be visible when standing above the installed filter.
- Lift your vent register from the floor, wall, or ceiling.
- Second, clean the register.
- Third, Flip the register over and rotate the grates 45 degrees.
- Slide the filter in through the grates. Insert the filter so the BLUE is the air EXIT side and the White side is where the air enters Then, push the filter into the remainder of the register until it sits flat between the angle grates and the top of the register.
- Return the vent register back in its place.
Replace every 30-60 days or when the filter looks dirty.
INSTALLATION OPTIONS #2
- Lift your vent register from the floor, wall, or ceiling.
- Clean the register.
- With the Vent Register face up, push the filter through an end slot on one side. Insert the filter so the BLUE is the air EXIT side and the White side is where the air enters
- Flip the register over.
- Rotate open the grates. Then, reach through the grates, grab the filter, and pull the filter all the way down to the end of the register.
- Sixth, even out the remaining portion of filter so it seats evenly inside the vent register.
Pro Tips! – Add some drops of your favorite smelling oils to your Vent Filters for great-smelling filtration!
AIR FILTRATION CUT TO FIT:
- Measure the opening of the vent register or intake register you want to filter.
- Transpose of those measurements to the filter using a marker or pen.
- Cut the filter.
- Wash the register to ensure long-lasting adhesion.
- Apply adhesive Velcro dots in the corners and middle of the register.
- After applying the dots to the surface, press the filter material firmly on the Velcro dots and rub the filter slightly back and forth. This will ensure the filter stays in place. Insert the filter so the BLUE is the air EXIT side and the White side is where the air enters
- Replace every 30-60 days or when the filter starts to look dirty.
Pro Tips! – Add some drops of your favorite smelling oils to your Vent Filters for great-smelling filtration!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>