BARKAHOLICS PATPET T410 Remote Dog Training Shock Collar User Manual

BARKAHOLICS PATPET T410 Remote Dog Training Shock Collar

Specifications:

• Brand: Patpet
• Model: 400
• Range: Up to 400 meters
• Functions: Impulse vibration, sound LED warning, intensity level setting
• Safety: CE mark for use in EU countries

Product Usage Instructions

Before First Use:
Adjust the collar for your dog’s comfort if it is too long before the first use.

Device Pairing:
Pair the device by following the instructions provided in the user manual.

Antenna:
Ensure the antenna is properly extended for optimal signal transmission.

Intensity Level Setting:
Adjust the intensity level setting based on your dog’s response to corrections.

Battery Status:
Regularly check the battery status to ensure the device is fully charged for maximum range.

Maximizing Reach:
To maximize reach, hold the transmitter furthest from your body and keep it fully charged.

FAQ:

• My dog doesn’t respond to corrections. What should I do?
  If your dog doesn’t respond to corrections, try adjusting the intensity level setting or consult a professional trainer for guidance.

FUNCTION:

• Rechargeable transmitter and receiver battery
• Short-term submersible and waterproof receiver
• Range up to 400 m
• Quick recharge – 2 hours until the battery is fully charged
• Possibility of expansion for up to 2 dogs
• Backlit LCD display – indicator of the strength of correction, battery status and indicator of the selected dog

PACKAGE CONTENTS

• Receiver
• Transmitter
• Dual USB charger
• Adjustable collar
• Test lamp
• Long and short electrodes + rubber cover
• Instructions

TIPS:

• Before using the device for the first time, fully charge it and test the functionality of the collar
• Always start training at the lowest level of electrical discharge and always monitor your dog’s behavior
• Before using el. shocks, try alerting the dog first by sound or vibration
• Always require the dog to perform only one command so that the dog is not confused. In training, be consistent and patient at the same time
• Each training collar must fit snugly against the skin. The electrodes must touch the skin but must not strangle the dog under the coat. Adjust the collar for your dog’s comfort if it is too long.

BEFORE FIRST USE:

•  Fully charge the transmitter and receiver using the included dual USB cable – during charging, the battery indicator light flashes on the radio display and the red indicator light above the display lights up. If the battery does not flash, the radio is fully charged (approx. 2-3 hours). When charging for the first time, this time is half as long.

DEVICE PAIRING

•  On the receiver, press the on/off button for 3 seconds until the receiver does not beep and the green light does not flash. Hold down the right button on the radio, you will hear an audio signal after successful pairing
• If you need to pair a second receiver, follow the same instructions, only need to switch to 2 dog channel
• After pairing is complete, test if all functions work properly. To test the el. discharges, attach the included test diode to the electrodes. After pressing the button for electric discharge, the diode starts to light up. To test the light on the radio, release the button briefly, to test on the receiver, press the button for a long time.

MAXIMIZING REACH

With the Patpet 400 collar, you have control over your dog up to a distance of 400 m. The range of functions varies depending on how the transmitter is held. To get maximum range, hold the transmitter, what furthest from the body. You will also ensure maximum range by keeping the transmitter fully charged.

NOTICE
The range of functions varies depending on how you hold the radio

SAFETY:

•  To ensure maximum effect and safety of your dog, check the placement the collar, its sufficient tightening and the correct placement of the electrodes. Also check the skin where the electrodes touch for rash or irritation. In this case, use the collar for shorter periods of time, or consult your veterinarian. The collar should not be worn continuously for more than 12 hours (this is a recommendation for all collars, even non-electric ones.

DEVICE FAILURE

The collar does not seem to be working properly:

• make sure both the transmitter and receiver are fully charged
• according to the instructions, pair the receiver with the radio
• make sure that the correction intensity is not at zero value
• make sure you have the correct channel (1 or 2) selected on your radio
• pair the collar, adjust the intensity and try the device again

RECEIVER OR TRANSMITTER WILL NOT CHARGE:

• make sure you have the network and device connectors properly connected
• test both devices for a fault in the charger or network

MY DOG DOESN’T RESPOND TO CORRECTIONS:

• test the receiver according to the instructions above
• make sure the electrodes are touching the skin
• increase the intensity of corrections

SPECIFICATIONS

TRANSMITTER

• Range – 400 m
• Power supply – rechargeable battery
• Charging time – 2 hours
• Display – backlit LCD display
• Antenna – Integrated
• Coverage – IPX1 (the most basic protection against water)
• Weight – 56 g
• Dimensions – 6.12 x 3.5 x 3.2 cm

RECEIVER

• Power supply – rechargeable battery
• Coverage – IPX5 (waterproof receiver)
• Adjustable collar circumference – 20-64 cm
• Weight – 56 g
• Dimensions – 6.12 x 3.5 x 3.2 cm

The device has been approved for use in EU countries and is therefore provided with the CE mark. All necessary documentation is available on the website: www.electric-collars.com Changes to technical parameters, properties and printing errors reserved.

Service center and distribution
Reedog, sro
Sedmidomky 459/8 101
00 Prague 10
Phone: +1 646 980 4569
Email: info@electric-collars.eu

References

• Vítejte v našem obchodě - Obojky.cz
• ★☆ Electronic training collars for dogs ☆★ - Electric-Collars.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>