FORCE WOLFIE Helmet for Cyclists Instruction Manual
- July 27, 2024
- FORCE
Table of Contents
EN 1078:2012+0A1:2012
HELMET FOR CYCLISTS
INSTRUCTIONS FOR USE
WOLFIE Helmet for Cyclists
This is a helmet for cyclists providing protection for the top of the user’s
head. Suitable for cycling or scooter riding. This product is personal
protective equipment whose primary function is to protect the top of the
user’s head from hazards that may arise during cycling and scooter riding
activities. The device protects the head from impacts where part of the impact
energy is absorbed by the helmet, thereby reducing the impact energy to which
the head is exposed. The protection provided by the helmet depends on the
circumstances surrounding the injury and cannot always protect against injury.
The helmet only protects if it is well seated on the head. The buyer must try
on different sizes and choose a helmet that ts his or her head securely and
comfortably. With the help of spare padding (not applicable for integral
helmets), the internal size can be adjusted to the optimum shape. The helmet
must be adapted to the user. Correct routing of the strap under the chin
without covering the ears is essential. The buckle, when properly adjusted,
should t snugly and comfortably under the chin (away from the jaw) so that
the helmet stays on the head in the event of a fall.
The straps and buckle must be comfortably and rmly adjusted. The helmet must
not be worn too far back and must t so as to protect the front of the head.
Original helmet components must not be removed or altered under any
circumstances. Do not expose the
helmet to temperatures exceeding 60°C, do not clean with synthetic agents
(lukewarm water is sufficient). Helmets damaged by a fall must no longer be
used! The helmet must not be used for activities other than those for which it
is intended (do not use when riding a motorcycle)! Warning! This helmet is not
to be used by children when climbing and other activities in which there is a
risk of strangulation/hanging by the helmet in the event of a child falling!
Never pull over the stop when adjusting the wheel! If the helmet has been
subjected to a severe impact the damaged piece must be replaced and disposed
of. Select the correct helmet size according to the head circumference in cm.
The above also applies to integral cycle helmets with regard to their
construction and specication. We declare that this cycle helmet complies with
Regulation (EU) 2016/425 of the European Parliament and of the Council of 9
March 2016 on personal protective equipment. Notied body involved in the
conformity assessment of PPE; Telecation BV, Edisonstraat 12A, 6902 PK
Zevenaar, Netherlands. NB 0560.TR:SZHH01403977. The current declaration of
conformity can be found on the website www.force.bike
in the “Documents to download” section for the product in question. KCK
Cyklosport-Mode s.r.o., Bartošova 348, 765 02 Otrokovice-Kvítkovice, Czech
Republic
Correct t of the helmet (points 1 and 2 do not apply to integral helmets):
- Look upwards to make sure you can only see the edge of the helmet.
- The side straps should be attached just below the ears, in the shape of a ‘Y’.
- When you fasten the strap and open your mouth wide, you should feel the helmet pulling down.
DOVOZCE/IMPORTER
KCK CYKLOSPORT-MODE S.R.O.,
BARTOŠOVA 348, 765 02 OTROKOVICE-KVÍTKOVICE, CZ
WWW.KCKCYKLOSPORT.CZ,
WWW.FORCE.BIKE
VÝROBCE/PRODUCER
ZHONGSHAN HENXIN SPORTS
EQUIPMENT CO, NO. 15 RAINBOW RD,
TANZHOU TOWN, ZHONGSHAN CITY,
GUANGDONG, CHINA
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>