sycamore LED com SY9027 Hera Tunable LED Bathroom Mirror Instruction Manual
- June 3, 2024
- sycamore LED com
Table of Contents
Installation instructions :
SY9027 Ares/SY9028 Hera Tunable LED Bathroom Mirror
with Demister
SY9027 Hera Tunable LED Bathroom Mirror
Thank you for purchasing this SycamoreLED.com product.
Please make sure instructions are followed carefully prior to and during
installation and product is not altered, otherwise warranty may not be valid.
For technical support or warranty information please visit
www.sycamoreLED.com, or call our dedicated technical helpline +44 (0) 113
2866686.
IMPORTANT—Please read prior to installation
- Please read these instructions carefully before commencing any work
- Please retain these instructions for future reference
- This unit must be installed by a qualified electrician in accordance with the IEE wiring regulations and building regulations
- To prevent electrocution switch the power off at the mains supply before installing or maintaining this fitting
- Ensure others cannot restore the electrical supply without your knowledge
CONTENTS & TOOLS REQUIRED
BATHROOM REGULATIONS
This product is IP44 rated and is suitable for installation in Zone 2 & Outside Zones
INSTALLATION INSTRUCTIONS
Colour Temperature (CCT) Change and Dimming
-
To select the preferred CCT, press the button on front of mirror to turn the light on/off until the correct CCT is achieved.
(2700K/4000K/6500K) -
The mirror will remember the chosen CCT next time the mirror is switched on. (as long as the setting was on longer than 8 seconds when last on).
-
To dim the light, hold down the button until the desired brightness is achieved.
-
Demister Function
-
Touch the button on the front of the mirror to turn the demister on/off.
-
Demister will switch off automatically after 30 minutes.
Shaver Socket
- Rated voltage:220-250V,50-60Hz
- Rated current:10A-16A
- The maximum wattage for the shaver socket is 19.2W.
CARE IN USE
- Please note this fitting has non replaceable parts
- Always switch off or disconnect from the mains when cleaning the product.
- We recommend cleaning with a soft dry cloth. Do not use scourers, abrasives or chemical cleaners.
- Do not allow moisture to come into contact with electrical parts
- This luminaire should not be disposed of with normal household rubbish. When a replacement is purchased, this luminaire should be returned to the retailer to safely dispose of (WEEE Directive effective July 2006—Waste from Electrical & Electronic Equipment)
This product contains a light source of energy efficiency class F
SycamoreLED.com
LS26 8XT
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>