Zebra ZD500 Direct Thermal Label Printer User Guide

June 4, 2024
ZEBRA

Zebra ZD500 Direct Thermal Label Printer

Zebra-ZD500Direct-Thermal-Label-Printer

Quick Setup:

  1. After completing the hardware setup, and having the printer connected to the network please follow these steps to setup the Zebra ZD printers outside of a registration App.

  2. Open a Web Browser (Safari) and type the printer’s IP Address on the Address Bar, press enter. You can find the IP address on the screen of your ZD500/ZD620. For non-screen models push and hold Feed + Cancel for 3-seconds to retrieve a status sheet.Zebra-ZD500Direct-Thermal-Label-Printer-1

  3. Once the “Internal Wired PrintServer” page loads select “View and Modify Printer Settings. Password is “1234”.

  4. Now go to “Media Setup” and set the “Sensor Type” and “Print Method” according to your badge-stock specifications. Most common options are Sensor Type: Mark
    Print Method: Direct Thermal.

  5. Select “Submit Changes”.

  6. Select once again “View and Modify Printer Settings” then select “General Setup”.

  7. Select once again “View and Modify Printer Settings” then select “General Setup”.

  8. Select “Submit Changes”.

  9. Now you can go to your registration/check-in app to do a Test print and confirm the printer is correctly set-up.

Setup Video Guide: Scan this QR code with your phone camera for video.

Contact our Support Team: www.choose2rent.com/help
+ 1 800-622-6484 Ext. 3 (USA)
+ 49 40 226 360 – 590 (Europe)

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals