VTech 80-183060 Switch and Go Triceratops Racer User’s Guide
- July 25, 2024
- vtech
Table of Contents
VTech 80-183060 Switch and Go Triceratops Racer
INTRODUCTION
Thank you for purchasing the Switch & GoTM Triceratops Racer! Engage your imagination with this speedy race car that transforms into a super cool Triceratops. 30+ sounds and phrases bring the action to life in your very own dinosaur universe.
INCLUDED IN THIS PACKAGE
- Switch & Go™ Triceratops Racer
- Parent’s guide
WARNING All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties and packaging screws are not part of this toy, and should be discarded for your child’s safety.
NOTE Please keep this parent’s guide as it contains important information.
GETTING STARTED
Battery Removal and Installation
- Make sure the unit is turned Off.
- Find the battery cover located on the bottom of the unit and use a screwdriver to loosen the screw and open the battery cover.
- Remove the old battery by pulling up on one end of it.
- Install 1 new AAA (LR03/AM-4) battery following the diagram inside the battery box.
- Replace the battery cover and tighten the screw to secure.
BATTERY NOTICE
- Use new alkaline batteries for maximum performance.
- Use only batteries of the same or equivalent type as recommended.
- Do not mix different types of batteries: alkaline, standard (carbon-zinc) or rechargeable, or new and used batteries.
- Do not use damaged batteries.
- Insert batteries with the correct polarity (+ and -).
- Do not short-circuit the battery terminals.
- Remove exhausted batteries from the toy.
- Remove batteries during long periods of non-use.
- Do not dispose of batteries in fire.
- Do not charge non-rechargeable batteries.
- Remove rechargeable batteries from the toy before charging (if removable).
- Rechargeable batteries are only to be charged under adult supervision.
PRODUCT FEATURES
-
On/Off/Volume Selector
To turn the unit On or adjust the volume, slide the switch to Low or High . To turn the unit Off, slide the to Off . -
Talk Button
Press the Talk Button to hear fun phrases from the dino or driver. -
Sound Effect Button
Press the Sound Effect Button to hear cool sound effects. -
Automatic Shut-Off
To preserve battery life, the unit will automatically shut off after approximately 20 seconds without input. The unit can be turned on again by pressing any button.
TRANSFORMATION
- Begin in Dino mode.
- Rotate the crest forward.
- Rotate the front legs toward the head.
- Rotate the back legs toward to the head. The unit is now in Vehicle mode.
NOTE To switch the vehicle back into a dino, follow the above steps in reverse order.
CARE & MAINTENANCE
- Keep the unit clean by wiping it with a slightly damp cloth.
- Keep the unit out of direct sunlight and away from any direct heat source.
- Remove the batteries when the unit will not be in use for an extended period of time.
- Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions, please follow these steps:
- Please turn the unit OFF.
- Interrupt the power supply by removing the batteries.
- Let the unit stand for a few minutes, then replace the batteries.
- Turn the unit ON. The unit should now be ready to play again.
- If the product still does not work, replace it with a new set of batteries.
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada, and a service representative will be happy to help you.
For information on this product’s warranty, please call our Consumer Services Department at 1-800-521-2010 in the U.S. or 1-877-352-8697 in Canada.
IMPORTANT NOTE: Creating and developing Infant Learning products is accompanied by a responsibility that we at VTech® take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to call our Consumer Services Department at 1-800-521-2010 in the U.S., or 1-877-352-8697 in Canada, with any problems and/or suggestions that you might have. A service representative will be happy to help you.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
- Trade Name: VTech®
- Model: 1830
- Product Name: Switch & Go™ Triceratops Racer
- Responsible Party: VTech Electronics North America, LLC
- Address: 1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004
- Website: vtechkids.com
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS:
- THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND
- THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
CAN ICES-3 (B)/NMB-3(B)
Caution: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
PRODUCT WARRANTY
- This Warranty is applicable only to the original purchaser, is non-transferable and applies only to “VTech” products or parts. This product is covered by a 3-month Warranty from the original purchase date, under normal use and service, against defective workmanship and materials. This Warranty does not apply to (a) consumable parts, such as batteries; (b) cosmetic damage, including but not limited to scratches and dents; (c) damage caused by use with non-VTech products; (d) damage caused by accident, misuse, unreasonable use, immersion in water, neglect, abuse, battery leakage, or improper installation, improper service, or other external causes; (e) damage caused by operating the product outside the permitted or intended uses described by VTech in the owner’s manual; (f) a product or part that has been modified (g) defects caused by normal wear and tear or otherwise due to the normal aging of the product; or (h) if any VTech serial number has been removed or defaced.
- Prior to returning a product for any reason, please notify the VTech Consumer Services Department, by sending an email to vtechkids@vtechkids.com or calling 1-800-521-2010. If the service representative is unable to resolve the issue, you will be provided instructions on how to return the product and have it replaced under Warranty. Return of the product under Warranty must adhere to the following rules:
- If VTech believes that there may be a defect in the materials or workmanship of the product and can confirm the purchase data and location of the product, we will at our discretion replace the product with a new unit or product of comparable value. A replacement product or parts assumes the remaining Warranty of the original product or 30 days from the date of replacement, whichever provides longer coverage.
- THIS WARRANTY AND THE REMEDIES SET FORTH ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES, REMEDIES AND CONDITIONS, WHETHER ORAL, WRITTEN, STATUTORY, EXPRESS OR IMPLIED. IF VTECH CANNOT LAWFULLY DISCLAIM STATUTORY OR IMPLIED WARRANTIES THEN TO THE EXTENT PERMITTED BY LAW, ALL SUCH WARRANTIES SHALL BE LIMITED TO THE DURATION OF THE EXPRESS WARRANTY AND TO THE REPLACEMENT SERVICE AS DETERMINED BY VTECH IN ITS SOLE DISCRETION.
- To the extent permitted by law, VTech will not be responsible for direct, special, incidental or consequential damages resulting from any breach of Warranty.
- This Warranty is not intended to persons or entities outside the United States of America. Any disputes resulting from this Warranty shall be subject to the final and conclusive determination of VTech .
To register your product online at www.vtechkids.com/warranty
FREQUENTLY ASKED QUESTIONS
What is the brand and model of the toy?
The toy is the VTech 80-183060 Switch & Go Triceratops Racer.
What are the dimensions of the VTech 80-183060 Switch & Go Triceratops Racer?
The dimensions of the VTech 80-183060 Switch & Go Triceratops Racer are 2.68 x 4.72 x 3.15 inches.
How much does the VTech 80-183060 Switch & Go Triceratops Racer weigh?
The VTech 80-183060 Switch & Go Triceratops Racer weighs 4.2 ounces.
What is the recommended age range for the VTech 80-183060 Switch & Go Triceratops Racer?
The VTech 80-183060 Switch & Go Triceratops Racer is recommended for children aged 4 to 8 years.
What type of battery does the VTech 80-183060 Switch & Go Triceratops Racer require?
The VTech 80-183060 Switch & Go Triceratops Racer requires 1 AAA battery.
What is the price of the VTech 80-183060 Switch & Go Triceratops Racer?
The VTech 80-183060 Switch & Go Triceratops Racer is priced at $11.99.
What is the warranty period for the VTech 80-183060 Switch & Go Triceratops Racer?
The warranty period for the VTech 80-183060 Switch & Go Triceratops Racer is 3 months.
Who is the manufacturer of the VTech 80-183060 Switch & Go Triceratops Racer?
The manufacturer of the VTech 80-183060 Switch & Go Triceratops Racer is VTech.
How do you operate the VTech 80-183060 Switch & Go Triceratops Racer?
The VTech 80-183060 Switch & Go Triceratops Racer is operated using control buttons and features a transformation mechanism. Make sure the AAA battery is properly installed for full functionality.
What materials are used in the construction of the VTech 80-183060 Switch & Go Triceratops Racer?
The VTech 80-183060 Switch & Go Triceratops Racer is made from durable plastic designed to withstand active play by children.
Why isn't the VTech 80-183060 Switch and Go Triceratops Racer turning on?
Ensure the batteries are properly installed and have sufficient charge. Check the battery compartment for any corrosion or loose connections. If the issue persists, try replacing the batteries with new ones.
What should I do if the VTech 80-183060 Switch and Go Triceratops Racer's sound is not working?
Verify that the volume is turned up and the sound switch is on. Check the batteries to ensure they are fully charged.
Why does the VTech 80-183060 Switch and Go Triceratops Racer not transform properly?
Ensure that all parts are properly aligned and there are no obstructions in the transformation mechanism. If parts are stuck, gently move them to the correct position.
How can I fix the VTech 80-183060 Switch and Go Triceratops Racer if it is not responding to button presses?
Check that the batteries are fully charged and correctly installed. Inspect the buttons for any dirt or debris that might be obstructing them.
Why does the VTech 80-183060 Switch and Go Triceratops Racer keep shutting off unexpectedly?
Make sure the batteries are fully charged and the battery compartment is securely closed. Overheating can cause shutdowns, so ensure the toy is not in a hot environment.
VIDEO – PRODUCT OVERVIEW
DOWNLOAD THE PDF LINK: VTech 80-183060 Switch and Go Triceratops Racer User’s Guide
REFERENCE:VTech 80-183060 Switch and Go Triceratops Racer User’s Guide- Device.Report
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>