KV2 audio ESR106 Wall Bracket Installation Guide
- July 25, 2024
- KV2 audio
Table of Contents
KV2 audio ESR106 Wall Bracket
Installation Steps
-
Step 1
Begin by preparing the wall bracket as shown in the first diagram. Ensure all screws and components are in place. -
Step 2
Proceed to the second diagram, where you will further secure the wall bracket with additional screws. -
Step 3
As depicted in the third diagram, attach the connecting piece to the wall bracket using the provided screws. -
Step 4
In the fourth diagram, align the bracket on the wall. There are two close-up views labeled A and B showing the correct positioning from different angles. -
Step 5
The fifth diagram shows the final installation measurements. The bracket should be mounted with a distance of 1967 mm from end to end, with the inner distance being 1927 mm.
Specifications
| Component | Measurement |
|---|---|
| Total Length | 1967 mm |
| Inner Distance | 1927 mm |
FAQ
Q: What tools are required for the installation?
A: You will need a screwdriver, a drill, and a measuring tape.
Q: Can the bracket be installed on any type of wall?
A: The bracket is designed for standard walls. For non-standard walls,
additional supports may be required.
Q: What is the weight capacity of the ESR106 Wall Bracket?
A: The bracket can support up to 50 kg.
Q: Are there any specific maintenance requirements?
A: Regularly check the screws and fittings to ensure they remain secure.