KV2 audio CS6 CS Series Compact High Quality 2 Way Passive Speaker User Guide
- June 5, 2024
- KV2 audio
Table of Contents
KV2 audio CS6 CS Series Compact High Quality 2 Way Passive Speaker
Important Safety Instructions
Before using your CS6, CS8, CS12 be sure to carefully read the applicable items of these operating instructions and the safety suggestions.
- Read all product instructions.
- Keep printed instructions, do not throw away.
- Respect and review all warnings.
- Follow all instructions.
- Clean only with dry cloth.
- Install in accordance with KV2 Audio’s recommended installation instructions.
- Only use accessories specified by KV2 Audio.
- Install the product only with rigging specified by KV2 Audio, or sold with the loudspeaker.
- An experienced user shall always supervise this professional audio equipment.
Introduction
The CS6 is a very high-quality 2-way passive speaker, presented conservatively in a low profile unique angled painted baltic birch enclosure. Designed to present exceptional speech clarity, the CS6 can be applied quickly and flexibly on podiums, stands and suspended as well as in fixed installations using the comprehensive range of ancillary attachments and brackets.
Features
- Professional Baltic birch construction with unique angles for flexible use
- Extremely hard-wearing textured plastic paint
- Compact enclosure allows discreet placement and application
- Wide dispersion 90 H x 90 V Horn
- KV2 Audio SLA technology passive crossover inc. thermal breaker protection
- 1”/ 1.3” Titanium diaphragm compression driver
- 6” Neodymium low mid woofer
- Fixing points for comprehensive attachments
Standard Connection
Parallel connection of the CS6 (8Ω) – Total impedance 2Ω. 2 wire or 4 wire
cable may be used, the AMP CHANNEL SELECTION switch does not apply. 
2 Channel Connection
Channel connection using single 4 wire cable (2 Channel Adapter Cable may be
used – KVV 987 450). Total impedance 4 Ω per channel. Channel switch for
selecting Signal 1 or Signal 2.
Note: It should NOT be switched during passing of signal as this could
potentially cause damage to the switch or amplifier). 
Wiring
All CS6 SPEAKON connectors are wired in parallel and the desired amplifier
channel is selected using AMP CHANNEL SELECTION switch. Terminal block (4
pins, 5.0mm pitch) is wired directly to the speaker, the AMP CHANNEL SELECTION
switch does not apply.
Drawing
Frequency characteristics
Frequency response
Horizontal Polar plots
Vertical Polar plots
Specifications
