ZEBRA KBD-ET8X Rugged Tablets Instructions
- July 23, 2024
- ZEBRA
Table of Contents
ZEBRA KBD-ET8X Rugged Tablets
Specifications
- Model : KBD-ET8X
- Compliance : Declaration of Conformity (DoC)
- Regulatory Compliance : FCC Part 15, ICES-003, EAC
- Support : zebra.com/support
- Warranty : zebra.com/warranty
Product Usage Instructions
Regulatory Compliance:
The KBD-ET8X complies with Part 15 of the FCC Rules and ICES-003. Make sure
the device does not cause harmful interference and can accept any received
interference.
Hazardous Locations:
Ensure the device is not used in hazardous locations to prevent potential
risks.
Support and Warranty:
For support, visit zebra.com/support. Warranty
information can be found at zebra.com/warranty.
Contact entitlementservices@zebra.com
for further assistance.
United States and Canada Regulatory: Radio Frequency Interference Notices
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received including interference that may cause undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
Innovation, Science and Economic Development Canada ICES-003 Compliance Label:
CAN ICES-3 ([B])/ NMB-3([B])
Hazardous Locations
- Class 1 Div 2 Product Regulatory Information
- Model KBD-ET8X-C1D2 has been system-assessed for use in hazardous locations, when attached to the
- Class 1 Div 2 compliant ET8X tablets marked UL listed for I.T.E HAZLOC.
- Observe all warning instructions marked on or provided with the Class 1 Div 2 device.
FAQ
Q: Where can I find software downloads for the KBD-ET8X?
A: Software downloads are available on zebra.com/support under the Products
section.