SECOMP VALUE 1x RJ4 5GbE PCI-Express Gen3 Network Adapter User Manual
- July 24, 2024
- SECOMP
Table of Contents
SECOMP VALUE 1x RJ4 5GbE PCI-Express Gen3 Network Adapter
Specifications
- Product Name: VALUE PCI-Express Gen3 Network Adapter
- Port: 1x RJ45
- Data Rate : 5GbE
- Model Number : 15.99.2187
- User Manual Version: 1.00
**Product Introduction
**
This product is a high-performance PCIe Ethernet adapter that provides a single RJ-45 port for network connection with a data rate of up to 5Gbps. The PCIe Gen3 x1 interface allows for maximum full-duplex throughput and is backward compatible with Gen1/2 PCIeslots.
Features
- PCIe Gen3 x1 form factor
- Supports standard and low-profile systems
- Supports 5-speed 5G/2.5G/1G/100M/10Mbps
- Auto-negotiation
- Supports Wake-On-LAN (WoL)
- Up to 16KB jumbo frame
- Checksum and TSO offload
- Network ARP and NS offload
- Supports PXE boot
System Requirements
- 32- and 64-bit operating systems are supported
- Windows 11/10
Package Contents
- 1 x PCIe 5G 5-Speed Multi-Gigabit Network Card
- 1 x User Manual
Getting Started
Hardware Layout
10M/100M/1000M/2.5G Link/Activity Indicator 5G Link/Activity Indicator
Link/Activity Indicator: LED
Link/Activity Indicator:
| LED | Description |
|---|
Link /Activity
LED| Indicates Link Speed:
• Solid Green = 10M/100M/1000M/2.5Gbps
• Solid Green = 5Gbps
Hardware Installation
- Turn off your computer.
- Unplug the power cord and remove your computer’s cover.
- Remove the slot bracket from an available PCIe slot.
- To install the card, carefully align the card’s bus connector with the selected PCIe slot on the motherboard. Push the board down firmly.
- Replace the slot bracket’s holding screw to secure the card.
- Secure the computer cover and reconnect the power cord.
Driver Installation
The following section shows you how to install PCIe 5G 4-speed Multi-Gigabit
Network Card driver on different operating systems.
Installation for Windows
Download the driver from www.secomp-international.com
Verifying the Installation: Verifying for Windows
- Click on the Device Manager tab in the Windows Control Panel. Start > Control Panel > Device Manager.
- Expand Network adapters, and you can read Realtek PCIe 5GbE Family Controller in the Device Manager.
Verifying the installation: Verifying for Windows
-
Click on the “Device Manager” tab in the Windows Control Panel.
Start > Control Panel > Device Manager -
Expand “Network adapters”, and you can read “Realtek
PCIe 5GbE Family Controller” in the Device Manager.
FAQ
Q: What operating systems are supported by the network adapter?
A: The network adapter supports 32- and 64-bit operating systems, specifically
Windows 11/10.
Q: What is the maximum data rate supported by the network adapter?
A: The network adapter supports data rates up to 5Gbps.