VELOSSA TECH 2019-2020+ Chevrolet Camaro SS BIG MOUTH Ram Air Intake Installation Guide
- July 21, 2024
- VELOSSA TECH
Table of Contents
VELOSSA TECH 2019-2020+ Chevrolet Camaro SS BIG MOUTH Ram Air Intake
Specifications
- Product Name : Chevrolet Camaro SS BIG MOUTH Ram Air Intake
- Model Year : 2019-2020+
Product Usage Instructions
Kit Contents
Please review the table below to ensure you have received all the necessary
components before starting the installation:
| Description | Qty in kit |
|---|---|
| M6 x 30mm socket head cap screw | 2 |
| Steel mount plate | 1 |
| M6 lock nut | 2 |
Stock Components Removal
Follow these steps to remove the stock components:
- Use a T15 driver to remove the specified screws and bolts.
- Utilize a non-marring pry tool for clips removal.
- Remove the bumper carefully, disconnecting the indicated
connector if needed.
Big Mouth Installation
Follow these steps to install the Big Mouth intake:
- Position the Big Mouth as shown in the diagram, ensuring proper placement.
- Mount the plate and insert bolts through the designated holes.
- Tighten the nuts in an alternating pattern, avoiding overtightening.
Finalize
Re-install the bumper following the same steps as removal to complete the
installation.
Kit Contents
- Please review this document before attempting installation.
- You will need basic hand tools and about 2 hours of installation time.
- Please review the table below and make sure you have received the kit contents.
Stock Components Removal
Use a T15 driver to remove the 8 screws shown below. The pop-up clips at
the ends can be removed with a non-marring pry tool.
Stock Components Removal
Use a T15 driver to remove the 4 screws shown below. Proceed to remove the 5
bolts (7mm) behind the fender liner that retain the bumper. Repeat on opposite
side.
Stock Components Removal
Locate and remove the 12 bolts (7mm) that trace the edge of the bumper (not
all the bolts are shown below)
Stock Components Removal
Proceed to unclip the bumper and handle gently. The bumper cannot be fully
removed unless the indicated connector is disconnected. However, full bumper
removal is not necessary if you can rest the bumper on a block without
stressing the wire loom.
Stock Components Removal
Remove the 3 ribbed clips that hold this plastic piece to the radiator
shroud and crash bar. This piece will not be reused.
Big Mouth Installation
The Big Mouth is meant to be tucked as shown below. Ensure that the cradle
mounting region grips the diagonal crossbeam. Push the rightmost area up under
the headlight and push down.
Big Mouth Installation
Place the mount plate behind the crossbeam and insert of the supplied bolts
through the right-side hole. Spin the nut on by hand, do not tighten yet.
Insert the other bolt in the passenger side hole and begin tightening both
nuts in an alternating pattern, SNUG IS ENOUGH. The body should seat itself as
shown below.
Finalize
FAQ
- Q: How long does the installation typically take?
- A: The installation usually takes about 2 hours with basic hand tools.
- Q: What tools are required for the installation?
- A: You will need a T15 driver, non-marring pry tool, 10mm wrench, and 5mm Allen key for the installation process.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>