LUNDERG Under Mattress Bed Alarm Pad User Guide
- July 17, 2024
- LUNDERG
Table of Contents
QUICK SETUP GUIDE
Under Mattress Bed
Alarm Replacement Pad
If you have any issue or question, contact us directly at questions@lunderg.com
STEP 1 TURN ON THE MONITOR
| |
---|---|---
Install batteries following +/-| Close cover with screwdriver| Turn ON
STEP 2 PAIRING
STEP 3 PAD PLACEMENT
|
---|---
Place bed pad under mattress (Early-Alert side to the edge)| Place mattress
down & wait until pad stops beeping
(10 sec to 2 min depending on mattress)
If pad was not placed before it stopped beeping, turn OFF bed pad, then ON (right) and repeat this step.
STEP 4 TESTING
|
---|---
Lay down on the bed| Sit on the edge of the bed and then exit bed
If Alarm didn’t sound, switch OFF bed pad first, then go back to step 1, and PAIR the device.
ALARM MUST SOUND
Cancel alarm by FIRMLY pressing “STOP” button
READY
THE SYSTEM IS READY TO USE
This is just a quick guide to get you started. To unlock the full potential
of your system, please read the user manual and check the full instructional
video!
Full Guide Video
www.Lunderg.com/underfullvideo
SUPPORT
QUESTIONS?
Contact us at
questions@lunderg.com
We will reply you within
24 hours, 7 days a week!