MINKA GROUP 3712-788 Mounting Plate Installation Guide
- July 16, 2024
- Minka Group
Table of Contents
MINKA GROUP 3712-788 Mounting Plate
Product Specifications
- Item Number: 3712-788
- Maximum Wattage: 60 watts per E12 base light bulb
- Fixture Compatibility: CFL or LED equivalent bulbs
- Mounting: Junction box installation
Frequently Asked Questions
Q: Can I use bulbs exceeding 60 watts in this fixture?
A: No, it is important not to exceed the maximum wattage rating to prevent damage to the fixture and ensure safety.
Q: What should I do if my junction box does not have a ground wire?
A: In the absence of a ground wire in the junction box, connect the fixture’s ground wire directly to the mounting plate using the green screw provided.
Q: Are CFL or LED bulbs included with the fixture?
A: No, CFL or LED bulbs are not included. You will need to purchase these separately and install them in accordance with the fixture’s specifications.
PREPARATION
(Fig.1)
- Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.
- Carefully unpack your new fixture and lay out all the parts in a clean area. Take care not to misplace any small parts necessary for installation.
MOUNTING THE FIXTURE
- Remove mounting plate (A) from back plate (E) by removing ball nuts (D) in front of back plate.
- Attach mounting plate (A) to junction box (JB) “not provided” with junction box screws (B). The side of mounting plate (A) with “GND” marked on it and two convex points must face out.
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wire as shown in Fig. 2, making sure that all the wire connectors are secured. If your junction box has a ground wire (green, or bare copper), connect fixtures ground wire to it. Otherwise connect fixture ground wire directly to mounting plate (A) using green screw provided.
-
Tuck wire connections neatly into junction box (JB).
FINISHING THE FIXTURE -
To mount the fixture to the wall, first slip the two mounting screws (C) through the mounting holes (F) in the back plate (E)
-
While holding fixture in place, thread the two ball nuts (D) at the end of the mounting screws (C), and tighten.
-
Install 2x E12 base light bulbs (LB) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification.
DO NOT EXCEED THE MAXIMUM WATTAGE RATING!
(NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. You can now turn the power ON and test the
fixture.
Note: Illustration (Fig. 1) on this manual is for installation purposes only.
It may or may not be identical to the fixture purchased.
MIN OF 75°C SUPPLY OF CONDUCTORS LES FIL D’ ALIMENTATION 75°C MIN.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>