Minka Group 5395-66A Inline Lighting Instruction Manual

: June 1, 2024
: Minka Group

Table of Contents

5395-66A Inline Lighting
Read User Manual Online (PDF format)
Download This Manual (PDF format)

5395-66A Inline Lighting

INSTALLATION INSTRUCTIONS

Item# 5395-66A (New. 2023/12/08)
READ AND SAVE THESE INSTRUCTIONS

W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

MOUNTING THE FIXTURE (Fig.1)

Shut off the power at the circuit breaker and remove the old
fixture, including the mounting hardware.
Carefully unpack your new fixture and lay out all the parts
on a clean area. Take care not to lose any small parts
necessary for installation.
Install stem (J) onto socket assembly (L), then thread
fixture arm (I) into stem (J).
Attach shade (K) over socket assembly (L) to all thread of
fixture arm (I), securing with finial (M).
Determine the desired hanging height and thread rods (G &
H) to coupling on fixture arm (I). Carefully feed wires
through each rod as you assemble. Note: Remove all
thread, if installing with one 6” rod only.
Attach fixture canopy (E) by threading onto rod (G).
Thread canopy screws (B) into pre-drilled holes in mounting
plate (A). Spaced same distance apart as holes in canopy
(E), and secure with nuts (D) provided. The length of
canopy screws (B) may be adjusted if necessary.
Attached mounting plate (A) to outlet box (Not included)
using mounting screws (C) (Size: #8-32N*L1”). The side of
mounting plate (A) marked with “GND” must face out.

CONNECTING THE WIRES (Fig. 2)

Connect the electrical wires as shown in Fig.2, making sure
that all wire connectors are secured. If your outlet box has
a ground wire (green or bare copper), connect fixture’s
ground wire and ceiling canopy’s ground wire to it.
Otherwise, connect fixture’s ground wire directly to
mounting plate (A) using ground screw provided.
Tuck the wire connectors neatly into the outlet box.
FINISHING THE INSTALLATION (Fig.1)
Raise canopy (E) over canopy screws (B) and secure
with cap nuts (F).
Install (3) three candelabra base bulbs up to 60 watts or
CFL or LED equivalent (not included) in accordance with
the fixture specification. — DO NOT EXCEED THE
MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!

Your installation is now complete. Return power and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be
identical to the fixture purchased.

Replace swivel to be loop system (Fig. 3)

Un thread nut (E4), then remove lock washer (E3), flat
plate (E2), swivel (E1) and rod (G) from canopy (E).
Attach one loop (O) to the other loop (O) by using quick
link (P).
Place loops (O) over canopy (E), then place flat plate
(E2) and lock washer (E3) onto protruding all thread at
top of loop (O), securing with hex nut (E4).
Install loops (O) onto top of rod (G).