SOLRIG B0CW5WYGQV 60 Inch Double K Shape Sliding Door Instruction Manual
- July 15, 2024
- SOLRIG
Table of Contents
CLOSET DOOR
INSTALLATION MANUAL
OPERATION CAUTIONS:
Please read this installation guide carefully before installation.
Please refer to the relevant content of this store for more product use.
Components list
Hardware
Tools required
Assembly Notes
Take aesthetics into account, ensure there is ample space for fascia installation. Therefore, install the track at a minimum distance of 5/8 inches away from the edge of the door opening
Product Installation
Step 1 Install clasp connector to the fascia
Seat the fascia on the track, and mark the clasp’s position on the fasica with
a pencil Step-2 Install the top track
Both the track and the fascia are trimmable. If the opening is not wide
enough, you can cut the track and the facisa to a workable length. But it’s
recommended to purchase the correct size for your opening directly. Center the
track on the head jamb if the opening is deep enough; otherwise, ensure a
5/8-inch gap from the jamb edge to the outer side of the track and mark holes
with pencil.
-
Mark each hole with pencil
-
Drill marks with drill bits
-
Attach track to the head jamb with longer screws (4.2mmx32mm
Step 3 Attach the roller to the door
Attention: There are two types of rollers. Please attach the same rollers to
one door.
The side with roller should be facing inward. The holes for finger pull are
pre-drilled. Please make sure the side with the pull hole is outward and the
roller should be attached to the other side of the door.
Lay the doors face down and seat the roller on the door top, about 1-3/16inch
away from the edge of the door and mark the drill point with pencil. Same
operation for two doors. Step 4 Hang the door to the track First
hold the door attached with C type roller (straight one) with at least 20
degree angle to hang the door to the back track Later hang the door attached
with B type roller( L-SHAPED) to the front track with 20 degree angle. Slide
the door close to the door jamb. If there is a gap between the door and the
door jamb, rotate the plastic gear until the gap is eliminated.
Step 5 Install floor guide
Assemble the floor guide. The nylon plate is removable and adjustable. Please
assemble the floor guide according to the door width. Our door thickness is
7/8inch. Following is the assembly way to match our door size. Slide the door
close to one door jamb and install the floor guide and secure with
screws(4.2mmx 19mm)
Step 6: Install finger pull
Insert round pull to the door hole and secure the handle with two pins. Step
7: Hange Fascia
Attention: On the track, there are three clasps, which is used to hold
the fascia. Hang the fascia to the track.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>