Senao AX3000 Indoor Ceiling AP Wall Mount Instruction Manual
- July 12, 2024
- Senao
Table of Contents
Senao IAP2300M
AX3000 Indoor Ceiling/Wall Mount AP
QSG
Hardware Overview
Ports
Mounting Method
The access point can be mounted on the Ceiling and Wall. Please perform the
following steps to install the device.
Ceiling Mount
- Screw the clips onto the bottom of the device.
- Hook the clips onto T-Rail until you hear a click.
Wall Mount
- Determine where the Access Point will be placed and mark the location on the surface for two mounting holes. Use appropriate drill bit to drill two 8.1mm diagram and 26mm-deep holes on the marks.
- Screw the Anchors into the holes until they are flush with the wall; screw the Screws into the Anchors but leave the screw head sticking out so you can hang the Access Point on it.
- Hang the Access Point against the wall onto the Screw heads.
Powering the AP
Connecting to a PoE Switch
Connect the Ethernet cable from the EnGenius Fit AP directly to the PoE
port of the PoE switch.
Powering with a PoE Adapter
(A) Connect one end of the Ethernet cable into the LAN (PoE) port of EnGenius
FIT AP and the other end to the PoE port on the PoE Adapter.
(B) Connect the power cord with the PoE Adapter and plug the other end into an
electrical outlet. (C) Connect the second Ethemet cable into the LAN port of
the PoE Adapter and the other end to the Ethemet port on the computer.
Powering with a Power Adapter
Connect the Power Cord to the adapter, and then plug the Power Cord into the
power outiet.
Statement
Senao Networks, Inc.
AX3000 Indoor Ceiling/Wall Mount AP
FCC ID: U2M-IAP2300M
1. USA—Federal Communications Commission (FCC)
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
INFORMATION TO USER:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy. If not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by tuning the equipment off and on, the
user is encouraged to try and correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna
- Increase the distance between the equipment and the receiver.
- Connect the equipment to outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Country Code selection feature to be disabled for products marketed to the US.
Operation of this device is restricted to indoor usage only.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>