Senao IAP2300AE Indoor Ceiling Mount AP Installation Guide
- June 16, 2024
- Senao
Table of Contents
Senao IAP2300AE Indoor Ceiling Mount AP Installation Guide
Package Contents
-
Indoor Access Point
-
Ceiling Mount Base (9/16″ T-Rail)
-
Ceiling Mount Base (15/16″ T-Rail)
-
Mounting Kit
Hardware Overview
Ports
Hardware Mounting
The access point can be mounted on the Ceilling and Wall, Please perform the following steps to install successfully
Ceiling Mount
T-Rail
-
Slide the Celling Mount Base into the designated slot on the access point slot of the Access Point.
-
Slightly hook the ceiling mount bracket onto the T-Rail until you hear a click.
Hard Ceiling
-
Screw the included Screws into the Ceiling Mount Base, and then screw the Screws into the surface until they are flush with the surface.
-
Slide the Access Point into the Ceiling Mount Base.
Wall Mount
-
Determine where the Access Point will be placed and mark the location on the surface for the two mounting holes. Use the appropriate drill bit to drill two 8.1mm diagram and 26mm-deep holes on the marks.
-
Screw the Anchors into the holes until they are flush with the wall; screw the included Screws into the Anchors but leave the screw head sticking out so you can hang the Access Point on it.
-
Hang the Access Point against the wall onto the Screw heads.
Powering the AP
Connecting to a PoE Switch
Connect the Themed cable from the Eugenius Fit AP directly to the PoE part of
the POE Switch.
Powering with a PoE Adapter
(A) Connect one end of the Ethernet cable into the LAN (PoE) port of EnGenius FIT AP and the other end to the PoE port on the PoE Adapter.
(B) Connect the power cord with the PoE Adapter and plug the other end into an electrical outlet. (C) Connect the second Ethernet cable into the LAN port of the PoE Adapter and the other end to the Ethernet port on the computer,
Powering with a Power Adapter
Connect the Power Cord to the adapter, and then plug the Power Cord into the
power outlet.
