WININMETA C1 Automatic Chicken Coop Door Instructions

WININMETA C1 Automatic Chicken Coop Door

Functional use

1. According to the work and rest time of the chicken, set the time switch corresponding to the chicken coop door.
2. Three control modes: manual control of the door’s opening and closing; timing control of the door’s opening and closing; light sensitive automatic control of the door’s opening and closing.
3. Two control methods: it can be controlled through the panel controller or through the mobile phone APP.
4. After the mobile app is connected to the chicken coop door, and then connected to WiFi, you can remotely control the opening and closing of the chicken coop door through the mobile app.
5. Intelligent chicken coop door, It can save man made time and prevent people from failing to open or close the door on time, causing the chicken door to be closed or opened for a long time, causing harm to the chicken.
6. The chicken door is strong and firm, which can prevent snakes, foxes, wolves and other beasts from raiding the chicken at night.
7. Charge the storage battery through the solar panel or USB cable, and then the storage battery supplies power to the chicken door to run, so you don’t have to worry about running out of power and frequent battery replacement.
8. Protection function: When the door is closed and there are chickens and other objects below it, there will be resistance gravity value sensing, and the door will rise and then fall to avoid pressing the chicken. When the door falls again and encounters an object such as a chicken, it will not rise again, but at this time, the chicken has left from below.

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body: Use only the supplied antenna.

Notice

1. Please install the solar panel in a place where it is easy to receive sunlight, and not in a dark place, so as to avoid insufficient power generated by the solar panel.
2. Wenn ein Fremdkörper unter der Tüür oder in der Schiene steckt, reinigen Sie ihn bitte rechtzeitig.
3. The light sensing and timing modes cannot be used at the same time, only one of them can be selected. To switch between the light sensing @and timing @modes, press and hold the @ button for 3 seconds.
4. When there is no direct sunlight for 10 consecutive days, please remove the solar panel and charge it with the charging cable.
5. Chicken coop doors are only suitable for WiFi Protocles 2.4G,802.11 b/g/n.
6. The closer the chicken coop door is to the router, the better the WiFi signal will be. It is recommended that the distance be within 20 meters.If the distance exceeds 20 meters, the WiFi signal becomes weaker, the power consumption increases, and the battery life is shortened.
7. The mobile app and the chicken coop door transmit through WiFi signals. In order to reduce the power consumption of the chicken coop door, the WiFi signal refresh time is 10 seconds. Set the value on the app and the chicken coop door sensing time is 1 to 10 seconds. When the induction is slow and lasts for 10 seconds, it is a normal phenomenon.

Packing list

• chicken coop door: 1
• Solar panel with battery: 1
• solar panel bracket: 1
• USB charging cable: 1
• Screws: 10
• Line card: 5
• Manual: 1 copy

Installation method

Find the position where the door needs to be installed on the wooden exterior wall outside the chicken house, cut out holes of appropriate size with special tools, and then install the door and fix it with screws.

1. Step 1: Cut a hole of suitable size with a special tool.
2. Step 2: Place the chicken coop door onto the cut door frame and secure it with screws.
3. Step 3: Install the solar panel on the dual purpose bracket, and then install the bracket on the roof of the chicken house, or on the sunny wall on the side of the chicken house, or insert it on the lawn and other places that are easy to receive light, as shown in the figure below Connect the wires as shown.

Introduction to panel controller operation

After no operation, the number flashes 5 times and then exits the current setting. When the photosensitive value of the environment where the chicken coop door is located is greater than the set value, the door of the chicken coop opens; when the photosensitive value of the environment where the chicken coop door is located is less than the set value, the door of the chicken coop is closed. If the chicken coop door is connected to Wifi, the current time will change back to network time.After the light
sensor is set, the sensing time for ambient light is 10 seconds. The longer sensing time is to avoid being disturbed by short–term light from the outside world.

door, you can manually open and close the door at any time.

Introduction to mobile APP control operations

1. Scan the following QR code with your mobile phone to download and install the APP.
2. Open the App and enter the following interface.
3. Click here to enter the following interface. Follow the instructions on this interface to connect your phone to the chicken coop door, and then connect to WiFi.
4. Wait for 10 seconds after connecting to the Internet, or pull down to refresh. The following screen will appear, on which you can see the remaining power.
5. Click here to enter the following interface, and you can operate the door. You can click to select different modes for operation. The operation functions are the same as those of the panel controller.

Basic parameters

• Color : black

• Material: aluminum alloy + AES

• Product size: 14.179.533.94in

• Weight: 1.54KG

• Battery capacity: 8000 mAh

• Input voltage: 5V

• Input Current 0.8A

• The output voltage 3.7V

• Output current 2A

• Solar panel dual purpose socket: It can be combined into a socket inserted on the grass, and can also be disassembled to be fixed on the roof of the chicken house or the wall on the side of the chicken house.

• Gravity value: 0~5N, the gravity of closing the door depends on the set gravity value. The gravity value for closing the door is set to 3N by default.

• Charging : Solar panel charging, or USB cable charging. When there is enough sunlight, the solar panel is fully charged in 45 hours. Charging using USB cable, it only takes 10 hours to fully charge.
  The indicator light of the solar panel battery box lights up red when charging and turns off when not charging or fully charged.

• Battery life: After being fully charged, it can last for 10 days without further charging.
  When the door is opened, the LED on the door will light up green; when the door is closed, the LED on the door will light up red.

• WORKS IN EXTREME WEATHER : This automatic coop door made of aluminum alloy and AES can work in snow, rain, and dust from 15°F to 140°F 26°C to 60°C). Protect your chickens from all weather conditions.

Product Maintenance
The sliding parts of the roller blind are lubricated. If the rolling shutter door is stuck after working for a long time, apply non fluid grease to the slide rails on both sides after opening the door.

FAQs and Troubleshooting

the light shine on the photosensitive body on the panel, and adjust  to  the appropriate  light-sensing
 | value according to different seasons and weather
---|---
Timing mode does not respond| Whether to switch to timing mode
Door drop pressure is too light, or too heavy| Whether to set the appropriate gravity value
Door stuck| Is there any foreign matter on the door track that has not been removed?
---|---
Doors open too early in the morning and close too late at night| Whether to set the appropriate door opening and closing time in the timing mode, and whether to set the appropriate light sensing value in the light sensing mode

Warranty aftersale
During the use of the automatic chicken coop door, if you have any unclear points, you can contact the seller for answers. In case of product quality problems, you can contact the seller for a replacement.

Seller email support@moreximi.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>