Miele HGXX Built Under Dishwasher Installation Guide
- July 9, 2024
- Miele
Table of Contents
Miele HGXX Built Under Dishwasher
FAQ
- Q: Can I perform electrical work on the appliance myself?
- A: No, installation work and repairs should only be done by a qualified technician following all codes and standards. Working on an energized circuit can cause serious injury.
- Q: What should I do if the power cord is damaged?
- A: If there is damage to the power cord or hoses, stop using the appliance immediately and contact a qualified technician for repair.
Installation diagram for built-under dishwashers / hardwired electrical connection
To prevent accidents and machine damage read the Operating / Installation and Important Safety Instructions before installation or use.
Safety Symbols
- See Operating Instructions.
- Risk of damage or fire hazard.
- Screw the feet in before moving the dishwasher.
- Do not use a cordless screwdriver, risk of damage.
- Warning, cutting hazard.
- The door springs must be set equally on both sides.
- Venting the water drainage
- If the on-site drainage connection is situated lower than the guide path for the lower basket rollers in the open door, the drainage system must be vented.
Safety Instructions
CAUTION: Before performing electrical work, disconnect the power supply by either removing the fuse, shutting off the power main or manually “tripping” the circuit breaker.
- Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer cannot be held responsible.
- Before connecting the appliance to the power supply, make sure that the voltage and frequency listed on the data plate correspond with the household electrical supply. This data must correspond to prevent machine damage.
- The power cord must not be kinked by the dishwasher feet when the dishwasher is pushed into the niche.
Sharp edges can damage the power cord and the hoses
- If the dividing panel inside your cabinet is made from wood, use sandpaper to round off the edges of the cut-out.
- If the dividing panel inside your cabinet is made from metal, you will need to order suitable edge protection from Miele Service.
What In The Box
- Fittings supplied depend on model.
- Tools required depend on model.
Dimensions
Installation Instructions
Warning
- If the intake hose will be coiled under the dishwasher after it is inserted in its niche, the undercounter height must be at least 32 7/8″ (835 mm) for standard height models) or 34 13/16″ (885 mm) for XXL height models.
- Do not sit the dishwasher on the hose. The hose needs to be free of kinks and able to move freely after installation. Do not place hose or power cord next to a heat source e.g. hot water pipes. Do not expose hose or power cord to corrosive substances.
- Damage of hose or power cord could cause electrical shock or water damage!
Information
Before you continue with the next steps, make sure that you have disconnected the power supply by either removing the fuse, shutting off the power main or manually “tripping” the circuit breaker. Working on an energized circuit could cause serious injury by an electrical shock! This work should only be performed by a qualified technician!
The existing flexible supply cord or cable shall have a minimum thickness of
AWG 14.
120 V, 60 Hz, 15 A fuse rating
- Black wire (live): connect to L
- White wire (neutral): connect to N
- Green wire (ground): connect to
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>