RASTAR Remote Control Car Instructions

July 8, 2024
RASTAR

Remote Control Car

“`html

Specifications

  • Product Types: 92840, 80445B308D7
  • Communication Technology: 2.4GHz
  • Charging Time: 4-5 hours
  • Maximum Charging Time: 10 hours

Product Usage Instructions

Battery Charge Instruction

To charge the battery, follow these steps:

  1. Connect the USB wire to a device with a USB port labeled as
    specified.

  2. Ensure the indicator light flashes at a normal speed.

  3. If there’s an issue with the circuit or battery (flashing three
    times faster), disconnect immediately and seek repair.

  4. Normal heating of the battery or USB wire during charging is
    expected.

  5. If unable to charge, check for damages or blockages.

Operation Guide

Direction Adjustment: Use the fixing piece to
twist the lock of the battery cover.

Battery Installation: Insert AA batteries into
the controller following polarity, then lock the battery cover.

Pairing: Transmitter needs to pair with the
model car before playing.

Battery Replacement: Replace batteries when LED
indicator dims.

Features & Function

This product uses 2.4GHz communication technology, allowing
multi-device and multi-user compatibility with fast response and
strong anti-interference capability.

Caution

  • Avoid mixing different types of batteries or new and used
    batteries.

  • Remove exhausted batteries from the toy.

  • Replace batteries under adult supervision with correct
    polarity.

  • Avoid short-circuiting the supply terminals.

FAQ

Q: How long does it take to fully charge the battery?

A: The charging time is 4 to 5 hours, not exceeding 10
hours.

Q: What should I do if the indicator light flashes abnormally

during charging?

A: Disconnect the USB plug immediately and seek repair from a
local service center or distributor.

“`

This manual is applicable to the following types of product: 92840, 80445B308D7.
1

BATTERY CHARGE INSTRUCTION
%HIRUHWKHILUVWXVDJHRUDIWHUDORQJSHULRGRIEHLQJXQXVHGFKDUJHWKH battery by connecting the USB wire to any device with label , label
*** and with USB port. Steps are as follows:
Remove the battery from the car before charging. Connect the battery to plug B of the USB wire, then connect plug A of the USB wire to the power source. The indicator light of the USB wire will turn on and flash in about 3 seconds (1.5 seconds per flash), which indicates the battery is being charged normally. When the light goes out, the charging is completed and power be will automatically cut off. If the indicator light doesn’t turn on, then the battery is full of power and has no need to be charged.
If the indicator light flashes three times faster than the normal speed, then something’s wrong with the circuit or battery. In this case, disconnect the USB plug immediately to cut off the power, and send the product to local service center or distributor for examination and repair.
Make sure the normal power supply of the USB plug before charging. Slight heating of the battery or USB wire during the charging is normal
phenomenon and will not affect the battery life or function. If the battery can’t be charged, check whether the battery or USB wire is
damaged, otherwise, check if the USB plug is blocked by any foreign object.

A USB Wire

B
Battery of vehicle

It takes 4 to 5 hours to fully charge the battery at rated voltage. The charge time shall not exceed 10 hours.

2

OPERATION GUIDE

Connector

DIRECTION ADJUSTMENT

LED INDICATOR

Switch OFF
Lock of cover ON-OFF SWITCH
7KH fixing piece for chassis can be used to twist the lock of the battery cover, please see the picture on the right.See picture 1.
2SHQ the fixed button at the bottom of model car according to the direction of arrow, place switch to “OFF” position; open the battery lid and connect the interface of battery pack with battery box’s power port, then close battery lid.
3OHDVH open the lid and put the 2 X 1.5V “AA” batteries into the controller according to its polarity, then close the lid and twist the chassis piece to lock the battery cover. See picture 2.
(YHU time before playing, the transmitter needs to pair with the model car as follows:
³The LED indicator on the transmitter will blink and ready for pairing. Switch on the model car, the LED on the transmitter will go out. This means the pairing process is completed. Then the model car can be fully controlled by the transmitter. See picture 3.
$GMXVW the direction DGMXVWPHQW switch to control the car running in a straight line.
3OHDVH replace battery when LED indicator becomes dark which means low battery.
7KH speed of model car will slow down when battery is low. 3OHDVH replace then.
*+] transmitters are compatible to control several model cars at same time without interference, provided that the pairing process is orderly done one by one following above steps. That is, first transmitter finishes pairing with first model car and keep their power on, then second transmitter can begin to pair with second model car…
3OHDVHWXUQRIIWKHPRGHOFDUDIWHUSODLQJ
3

FEATURES & FUNCTION

This product uses 2.4GHz communication technology, which is compatible for multi-device and multi-user, with fast response speed, high response precision, and strong anti-interference capability.

FORWARD REVERSE

LEFT RIGHT

DIRECTION ADJUSTMENT

BATTERY

BATTERY
CONNECTOR ON/OFF SWITCH

Function: Forward, Reverse, Turn Left, Turn Right, Headlight, Rear Light. Features: Authentic car styling with injection moulded body, independent suspension system.
CAUTION
Different types of batteries or new and used batteries are not to be mixed. Exhausted batteries are to be removed from the toy.
Replace the batteries under adult supervision.Batteries are to be inserted with the correct polarity. The supply terminals are not to be short-circuited.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy before being charged. Batteries are to be charged by an adult, leaked or broken batteries are not to be charged.
Rechargeable batteries are only to be charged under adult supervision. Only batteries of the same or equivalent type are recommended to be used. The wire, USB wire or battery plug are not to be inserted into output socket.
4

1HYHU SXW WKH EDWWHULHV QHDU ILUH RU DQ VRXUFH RI KHDW ZDWHU RU GLUHFW sunlight.
6NLQ RU FORWKLQJ LV WR EH ZDVKHG LPPHGLDWHO LI RX PDNH FRQWDFW ZLWK OHDNHGOLTXLGIURPWKHEDWWHU
)RUEHWWHUSUHVHUYDWLRQRIUHFKDUJHDEOHEDWWHULHVSOHDVHUHJXODUOUHFKDUJH WKHP2QODFKDUJHURIWKHVDPHRUHTXLYDOHQWWSHLVUHFRPPHQGHGWREH used.
,WLVVXJJHVWHGWRFKDUJHWKHEDWWHUDWOHDVWRQHWLPHHDFKWKUHHPRQWKV in order to maintain the lifetime of battery.
86%FKDUJLQJZLUHLVQRWDWR &DQRQOXVHVXSSRUWLQJ86%FKDUJLQJZLUHSURYLGHGE5$67$5*5283 86%FKDUJLQJZLUHDQGEDWWHULQWKHWHSLGLVDQRUPDOSKHQRPHQRQZKHQ
charging. %DWWHULHVPXVWEHUHJXODUOFKHFNHGIRUGDPDJH ‘LVSRVHRIEDWWHULHVUHVSRQVLEOGRQRWGLVSRVHRILQILUH

When your vehicle starts to lose power, it may lose its functions or performance. This indicates that it’s time to refresh your batteries or recharge them.

‘R QRW RSHUDWH RXU FDU RQ WKH streets where people gather or under
high voltage wires. Stay safe!

‘RQ
W GULYH RXU YHKLFOH LQ VDQG through water or snow.

3RLQWRXUWUDQVPLWWHUDQWHQQDXSQRW down toward your vehicle. If your vehicle gets too far away, it won’t work properly. If your transmitter has an antenna carry-loop feature, make sure the antenna is removed from the holder and straightened before operating.

‘RQ
WSXWRXUYHKLFOHQHDUKHDWRULQ direct sunlight. Always turn switches
OFF after operating.

Car pictures demonstrated above may vary from the toys.
5

MAINTENANCE AND REPAIR

5HPRYHWKHEDWWHULHVZKHQWKHXQLWLVQRWLQXVHIRUORQJSHriods of time. &OHDQWKHYHKLFOHZLWKDVRIWFORWK $YRLGEHLQJKHDWHGRUEHLQJH[SRVHGWRVWURQJVXQOLJKW .HHSGU 5HJXODUO H[DPLQH USB charging wire for DQ damage to its wire, plug,
enclosure and other parts, and WKH must not be used until the damage has been repaired.
%DWWHULHVPXVWEHUHJXODUOFKHFNHGIRUGDPDJH

127(7KLVHTXLSPHQWKDVEHHQWHVWHGDQGIRXQGWRFRPSOZLWKWKHOLPLWVIRU D&ODVV%GLJLWDOGHYLFHSXUVXDQWWRSDUWRIWKH)&&5XOHV 7KHVHOLPLWVDUHGHVLJQHGWRSURYLGHUHDVRQDEOHSURWHFWLRQDJDLQVWKDUPIXO interference in a residential installation. 7KLVHTXLSPHQWJHQHUDWHVXVHVDQGFDQUDGLDWHUDGLRIUHTXHQFHQHUJDQG LIQRWLQVWDOOHGDQGXVHGLQDFFRUGDQFHZLWKWKHLQVWUXFWLRQVPDFDXVHKDUPIXO interference to radio communications. +RZHYHUWKHUHLVQRJXDUDQWHHWKDWLQWHUIHUHQFHZLOOQRWRFFXULQDSDUWLFXODU installation. If this equipment does cause harmful interference to radio or WHOHYLVLRQUHFHSWLRQZKLFKFDQEHGHWHUPLQHGEWXUQLQJWKHHTXLSPHQWRII DQGRQWKHXVHULVHQFRXUDJHGWRWUWRFRUUHFWWKHLQWHUIHUHQFHERQHRUPRUH of the following measures: ²5HRULHQWRUUHORFDWHWKHUHFHLYLQJDQWHQQD ²,QFUHDVHWKHVHSDUDWLRQEHWZHHQWKHHTXLSPHQWDQGUHFHLYHU –Connect the equipment into an outlet on a circuit different from that to which WKHUHFHLYHULVFRQQHFWHG ²&RQVXOWWKHGHDOHURUDQH[SHULHQFHGUDGLR79WHFKQLFLDQIRUKHOS

7KLVGHYLFHFRPSOLHVZLWK3DUWRIWKH)&&5XOHV Operation is subject to the following two conditions:
WKLVGHYLFHPDQRWFDXVHKDUPIXOLQWHUIHUHQFHDQG WKLVGHYLFHPXVWDFFHSWDQLQWHUIHUHQFHUHFHLYHG LQFOXGLQJLQWHUIHUHQFHWKDWPDFDXVHXQGHVLUHGRSHUDWLRQ

:DUQLQJ&KDQJHVRUPRGLILFDWLRQVWRWKLVXQLWQRWH[SUHVVODSSURYHGE WKHSDUWUHVSRQVLEOHIRUFRPSOLDQFHFRXOGYRLGWKHXVHU¶VDXWKRULWWR operate the equipment.

)UHTXHQFEDQGV 2400MHz to 2483.5MHz
0D[LPXP7UDQVPLWWLQJ3RZHU(,53 Not more than 10mW.

WARNING:
CHOKING HAZARD-Small parts. Not for children under 3 years.

The instruction has to be kept since it contains important information.
RASTAR GROUP
Add: Xinghui Industrial Park, Xiadao Road, Shanghua, Chenghai, Shantou, Guangdong, China. Http://www.rastar.com
6

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals