BRAUN IS-1511 CareStyle 1 Pro Steam Station Instruction Manual
- July 5, 2024
- Braun
Table of Contents
BRAUN IS-1511 CareStyle 1 Pro Steam Station
www.braunhousehold.com/register
Please read safety instructions (separate booklet) carefully and completely before using the appliance.
Description
- Temperature selector
- Steam button
- Temperature control LED
- Clean LED / button
- 2-in-1 tray: removable iron rest + cleaning vessel
- Lock system
- Lock system for 2-in-1 tray
- Removable water tank
- Double cord/double cord storage
- Power cord
- Heel rest
Intended use
The appliance must be used only for ironing garments which are suitable for
ironing according to the care label. Never iron or dampen garments while
wearing them.
Filling the water tank
(for details refer to fig. A)
Make sure the appliance is plugged off. If you have extremely hard water, we
recommend that you use 50 % tap water and 50 % distilled water. Do not use
condensation water from a tumble dryer.
Start into operation
Before first use
Steam settings
(for details refer to fig. D)
Temperature
level 1 (•) Synthetics
level 2 (••) Wool, silk, polyester
level 3 (•••) Cotton, linen
Auto-off
Descaling (for details refer to fig. F)
The system will remind you to descale it regularly independent of the type of
water used. Descaling can be performed at any time needed even when not
indicated by the system.
If the «clean» LED (4) and the acoustic signal turn on during an ironing
session, it is possible to continue ironing. There is no need to perform the
cleaning immediately. The cleaning procedure can be performed when the ironing
session has been fi nished or next time the appliance is switched on.
If the appliance is switched off without having performed the cleaning process, the «clean» LED and acoustic signal will turn on again when it is next switched on. If there is no steam supply from the iron and the following conditions are present: clean LED “on” , temperature control LED “fl ashing” and acoustic signal “active” then the cleaning process will be mandatory to perform in order to proceed with the ironing session.
Caution : Do not leave the appliance unattended during the descaling
process. Always perform the descaling process with the cleaning vessel. Do not
interrupt the process by lifting the iron up from the cleaning vessel, as hot
water and steam will come out of the soleplate.
Caution : The cleaning vessel can be hot and contains hot water, take
care while moving and emptying it.
After ironing / storage
Troubleshooting guide
PROBLEM
The iron does not produce any steam
| SOLUTION
Press and hold the steam button until steam comes out. It may take up to 30 seconds until steam comes out.
Perform the cleaning process if the «clean» system LED turns on (see dedicated chapter).
Wait until the iron heats up and the temperature control LED turns permanently on.
---|---
The appliance has switched off| The auto-off mode is activated. To switch the
iron on again, select a temperature level. The appliance starts to heat up
again.
---|---
During ironing white particles and impurities are coming out from the
soleplate| If you have extremely hard water, we recommend that you use 50 %
tap water and 50 % distilled water.
Perform the cleaning process regularly even if not required by the system.
The first time the appliance is turned on you notice smoke/smell.| This is
normal and will stop after the iron has been used a few times.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>