T3 LUCEA 1 Inch Professional Hair Straightener User Guide
- July 3, 2024
- T3
Table of Contents
T3 LUCEA 1″
User Guide
1″ professional straightening and styling iron
Model No.76520, 76521, 76522, 76523, 76524, 76525, 76526,
76527, 76528, 76529, 76530, 76531,76532, 76533, 76534
THIS PAGE INTENTIONALLY
LEFT BLANK
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
When using electrical appliances, especially when children are present,
basic safety precautions should always be followed, including the following:
DANGER
KEEP AWAY FROM WATER
Electricity and water are a dangerous combination and can cause death by
electric shock. Do not allow electrical cords to come into contact with water
or other liquids.
ELECTRICAL APPLIANCES ARE ELECTRICALLY LIVE WHEN PLUGGED IN, EVEN IF TURNED
OFF.
To reduce the risk of death by electric shock:
- Always unplug the appliance immediately after using.
- Do not use while bathing.
- Do not place or store the appliance where it can fall or be pulled into a bath tub or sink.
- Do not place in or drop into water or other liquid.
- If the appliance falls into water, unplug it immediately. Do not reach into the water.
WARNING
To reduce the risk of burns, electrocution, fire or injury to persons:
-
An appliance should never be left unattended when plugged in.
-
Close supervision is necessary when this appliance is used on, or near children or individuals with certain disabilities.
-
Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
-
Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or dropped into water. Return the appliance to a service center for examination and repair.
-
Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
-
Never use while sleeping.
-
Never insert any object into the styling iron.
-
Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
-
Do not use an extension cord with this appliance.
DANGER -
This styling iron is hot when in use. Do not let eyes and bare skin touch the heated surfaces.
-
Do not place the heated styling iron directly on any surface while it is hot or plugged in.
-
Do not use if the plug is loose in the outlet, as there may be risk of fire, electric shock, electrical shortage and burning.
-
Make sure to remove the plug from the wall outlet after use.
Do not use the appliance near a bath tub, washbasin or other vessel filled
with water. Never place the appliance in water or any other liquid.
SAVE THESE INSTRUCTIONS
MAINTENANCE INSTRUCTIONS
-
Your appliance is virtually maintenance free. It contains no user serviceable parts, and no lubrication is needed.
-
Keep heated surfaces clean and free of dust, dirt & hairspray.
-
If cleaning becomes necessary, disconnect the appliance from the power source and let it cool. Wipe the exterior with a damp cloth.
-
If any malfunction occurs, unplug the appliance, allow it to cool and return it to a service center to repair.
-
Never wrap the cord around the appliance since this will cause the cord to wear prematurely and break.
If the cord becomes twisted, untwist it prior to use. -
Handle the cord carefully for longer life and do not put any stress on the cord where it enters the handle. Avoid jerking, twisting or straining especially at the plug connections. It could cause the cord to fray and possibly break.
-
Do not attempt to repair the appliance yourself.
STORAGE
When not in use, your styling iron should be disconnected and stored in a
safe, dry location, out of reach of children. Do not wrap the cord around the
styling iron. Allow the cord to hang or lie loose and straight at the point of
entry into the styling iron.
T3 LUCEA 1″
SERVICING OF DOUBLE-INSULATED APPLIANCES
In a double-insulated appliance, two systems of insulation are provided
instead of grounding. No grounding means is provided on a doubleinsulated
appliance, nor should a means for grounding be added to the appliance.
Servicing a double-insulated appliance requires extreme care and knowledge of
the system, and should be done only by qualified service personnel.
Replacement parts for doubleinsulated appliance must be identical to the parts
they replace. A doubleinsulated appliance is marked with the words “DOUBLE
INSULATION” or “DOUBLE INSULATED”. The symbol (square within a square) may
also be marked on the appliance.
OPERATING INSTRUCTIONS
T3 LUCEA 1″
This appliance is intended for household use. Use on Alternating Current
(60/50Hz) only.
This appliance has a polarized plug (one blade is wider than the other).
As a Safety feature, this plug will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician. Do not attempt to defeat this safety
feature.
WARNING
AUTO SHUT-OFF
After approximately one hour, the unit will automatically shut itself off. To
reactivate the unit, press the Power & Temperature Button.
AUTO WORLD VOLTAGE
This appliance contains a special electronic circuit that automatically
converts it for worldwide usage – from 120VAC 60 HZ to 240VAC 50 Hz. Just plug
it into the local power outlet and use it as normal; the styler will
automatically adjust to the local current. You may need a plug adapter to
allow the plug to fit into the local outlets.
Note: Tool heat up time may vary based on country and voltage.
T3 LUCEA 1″
CAUTION
Do not let the heated plates touch your skin as you may get burnt.
T3 LUCEA 1″
TEMPERATURE GUIDE
For optimal results, select the right heat setting for your hair type. See
temperature guide below to determine your heat setting. We suggest starting at
a lower setting and building your way up as needed.
* If your hair is color-treated, reduce temperature by 1-2 heat
settings for optimal results.
-
Press the Power & Temperature Button to turn the iron on. Lights will cascade up, then turn solid when the unit is ready to use. Note: Each time you turn on the iron itwillheatuptothe last set temperature.
-
To change the temperature, double click the Power & Temperature Button.
Then continue to click to cycle through to your exact temperature setting. -
Release the Power & Temperature Button after selecting your desired temperature.
The temperature lights will cascade up or down to your selected temperature. Lights will turn solid when the iron is ready to use. -
To turn off the iron, press and hold the Power & Temperature Button until the lights turn off.
*See Temperature Guide on page 10 for recommended settings.
T3 LUCEAT
T3 THERMATOUCH® TECHNOLOGY
Advanced insulation technology makes the arms of the flat iron more
comfortable to hold. However, as any other heat styling tool, this flat iron
must be used with caution. Avoid touching the side of the flat iron arms,
where the plates are hot.
CORRECT INCORRECT
HOW TO USE YOUR
T3 LUCEA 1″
- Start with dry, detangled hair. Twist the top part of your hair out of the way and secure it with a sectioning clip. Gather the rest of your hair into another clip, leaving a 1-2″ section out to begin styling.
- To avoid kinks, style your hair using thin, horizontal sections so the iron can be positioned close to the roots.
- Glide iron through in the direction of hair growth at a speed slower than when brushing hair.* Continue working with thin sections repeating steps 2 and 3 until hair is fully styled.
*Expert Tip:
Slow down for perfect results in a single glide:
Fine hair: Glide iron at 2-3 inches per second Medium Hair: Glide iron at 2
inches per second Coarse Hair: Glide iron at 1 inch per second
T3 LIMITED WARRANTY TERMS & CONDITIONS
T3 Micro will repair or replace (at our option) T3 products for twenty-four
(24) months from the date of purchase if they are defective in workmanship or
materials. This limited warranty does not cover (1) damage due to misuse or
abuse, such as incorrect voltage supply, dropping, or failure to follow
enclosed instructions or (2) tampering, such as repair or attempt to repair.
To obtain service under this warranty, please visit www.T3Micro.com/warranty-
info to submit a warranty claim, or
call us at 866-376-8880 to receive
detailed instructions. You will be required to provide proof of purchase.
THIS LIMITED WARRANTY IS ONLY VALID IF THE PRODUCT IS PURCHASED FROM AN
AUTHORIZED SELLER OF T3 GOODS AND IF THE ORIGINAL SERIAL NUMBER ON THE PRODUCT
HAS NOT BEEN REMOVED OR OTHERWISE TAMPERED WITH.
Any implied warranties, obligations, or liabilities, including but not limited
to the implied warranty of merchantability and fitness for a particular
purpose, shall be limited in duration to the 24 month duration of this written
limited warranty. Some states do not allow a limitation on how long an implied
warranty lasts, so the above limitation may not apply to you.
IN NO EVENT SHALL T3 BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED.
Visit www.T3Micro.com/customer-service to complete your warranty registration.
SUPPLIER’S DECLARATION OF CONFORMITY 47 CFR § 2.1077 COMPLIANCE
INFORMATION
Model Name:
T3 Lucea 1″
Model Description:
1″ professional straightening and styling iron
Model Number:
76520, 76521, 76522, 76523, 76524, 76525, 76526, 76527, 76528, 76529, 76530,
76531, 76532, 76533, 76534
Responsible Party in USA:
T3 Micro, Inc.
301 Santa Monica, CA 90401
866.376.8880
Test Report Number:
240412190GZU-001
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occurina particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY 47 CFR § 2.1077 COMPLIANCE INFORMATION
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
No change or modification to this equipment shall be made without the express
written approval of the “responsible party” as defined in the FCC’s rules.
MODEL NO.
76520, 76521, 76529, 76523, 76524, 76525, 76526, 76527, ‘76528, 76529, 76530,
76531, 76532, 76533, 76534
SPECIFICATIONS
Operating Voltage 120-240VAC, 60/50HZ, 53W
Power Consumption: 53W
13 Micro, INC.
Santa Monica, CA USA/(ETATS-UNIS)/EE.UU.
Made in China
WARNING
Do not use the appliance near a shower, bathtub, washbasin or other vessel
filled with water. Never place the appliance in water or any other liquid.
0184-76520-L
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>