T3 73311 Source Filter Showerhead User Guide
- June 15, 2024
- T3
Table of Contents
T3 73311 Source Filter Showerhead
WHAT’S INCLUDED
SHOWE RHEAD
-
Showerhead
-
Filter 73305
-
Plumber’s Tape
HOW TO USE YOUR
YOU WILL NEED
1 inch open end wrench or adjustable crescent wrench
INSTALLATION PROCEDURE
-
Unscrew existing showerhead from pipe. Clean the threads. Wrap plumbers tape clockwise around pipe threads.
-
Screw the T3 Source Showerhead into place and flush with hot water for 1 minute before showering.
Tip: If your showerhead is difficult to remove, try the following:
- Soak joint area with vinegar to break down calcium deposits and/or wrap a wet, hot towel around area to loosen joints.
- Grasp the pipe with a crescent wrench and unscrew the showerhead with a pipe wrench. Use caution so as not to cause damage.
HOW TO REPLACE YOUR FILTER
FILTER INSTALLATION PROCEDURE
- Unscrew the top and bottom halves of the T3 Source.
- Remove used filter and recycle by puncturing screen and emptying contents into garden or flushing down drain.
- Recycle plastic container.
- Remove 0-ring from inside of T3 source and clean as necessary.
- Lightly lubricate 0-ring groove inside showerhead with Vaseline® before re-installing ring.
- Remove sticker from each end of new filter.
- Drop in new filter and screw housing halves together.
- Flush with hot water for a full 1 minute before showering.
Filter Replacement
Purchase replacement filter online from the retailer where you purchased this
unit or visit www.T3Micro.com. For optimal
performance, your filter should be replaced every 6 months or when the filter
replacement indicator turns black. Order Filter Number: 73305
HOW TO REPLACE YOUR FILTER
PERFORMANCE DATA
Rated Service Flow – Maximum 2.0 gallons per minute/ 7.5 liters per
minute
Maximum working pressure – 80 pounds per square inch/ 552 kilo pascals
Maximum operating temperature – 120°F / 49°C
This system has not been evaluated for free available chlorine reduction performance in the presence of chloramines. Free available chlorine reduction performance may be impacted by the presence of chloramines in the water supply. Please contact your local water utility to determine if chloramines are used in treating your water.
System is Certified by IAMPMO R&T to NSF/ANSI 177 for chlorine reduction.
Notes: Actual performance may vary. Filtration system not intended to be used as a drinking water treatment unit. System and installation must comply with applicable state and local regulations.
T3 LIMITED WARRANTY TERMS & CONDITIONS
T3 Micro will repair or replace (at our option) T3 products for twenty four
(24) months from the date of purchase if they are defective in workmanship or
materials. This limited warranty does not cover (7) damage due to misuse or
abuse during installation and thereafter or (2) tampering, such as repair or
attempted repair. To obtain service under this warranty, please visit
t3micro.com/warranty claim to submit a warranty
claim, or call us at 866-376-8880 to
receive detailed instructions. You will be required to provide proof of
purchase.
THIS LIMITED WARRANTY IS ONLY VALID: (1) IF YOU CAN PROVIDE PROOF OF PURCHASE;
(2) IF THE PRODUCT IS PURCHASED FROM AN AUTHORIZED SELLER OF T3 GOODS.
Any implied warranties, obligations, or liabilities, including but not limited
to the implied warranty of merchantability and fitness for a particular
purpose, shall be limited in duration to the 24 month duration of this written
limited warranty. Some states do not allow limitation on how long an implied
warranty lasts, so the above limitation may not apply to you.
IN NO EVENT SHALL T3 BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED.
Visitwww.t3micro.com/register to
complete your warranty registration.
Model No.
73302, 73311
T3 Micro, Inc.
Venice, CA USA
Made in China
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>