T3 76895 Hair Dryer User Guide
- June 16, 2024
- T3
Table of Contents
- IMPORTANT SAFETY INSTRUCTIONS
- GROUND FAULT CIRCUIT INTERRUPTERS
- OPERATING INSTRUCTIONS
- HOW TO USE YOUR
- MAINTENANCE INSTRUCTIONS
- T3 LIMITED WARRANTY TERMS & CONDITIONS
- SUPPLIER’S DECLARATION OF CONFORMITY 47 CFR § 2.1077 COMPLIANCE
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
T3 76895 Hair Dryer User Guide
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety precautions should always be followed including the following.
DANGER
KEEP AWAY FROM WATER
Electricity and water are a dangerous combination and can cause death by electric shock. Do not allow electrical cords to come into contact with water or other liquids.
ELECTRICAL APPLIANCES ARE ELECTRICALLY LIVE WHEN PLUGGED IN, EVEN IF TURNED OFF.
To reduce the risk of death by electric shock:
- Always unplug the appliance immediately after using.
- Do not use while bathing.
- Do not place or store the appliance where it can fall or be pulled into a bath tub or sink.
- Do not place in or drop into water or other liquid.
- If the appliance falls into water, unplug it immediately. Do not reach into the water.
To reduce the risk of burns, electrocution, fire or injury to persons:
- An appliance should never be left unattended when plugged in.
- Close supervision is necessary when this appliance is used on, or near children or individuals with certain disabilities.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by the manufacturer.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, or if it has been dropped, damaged, or dropped into water. Return the appliance to a service center for examination and repair.
- Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
- Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair and the like.
- Never use while sleeping.
- Never drop or insert any object into any opening.
- Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use an extension cord with this appliance.
- Do not direct hot air toward eyes or other heat sensitive areas.
- Attachments may be hot during use. Allow them to cool before handling.
- Do not place the appliance, while it is operating, on any surface.
- While using the appliance, keep hair away from the air inlet.
- Do not operate with a voltage converter.
Do not use the appliance near a bath tub, washbasin or other vessel filled with water. Never place the appliance in water or any other liquid.
GROUND FAULT CIRCUIT INTERRUPTERS
If you must use your hair dryer in the bathroom, install a GFCI now! Your local electrician can help you decide which type is best for you – a portable unit that plugs into the electrical outlet ora permanent unit installed by your electrician. The National Electrical Code now requires GFCIs in the bathroom, garages and outdoor outlets of all new homes,
Why do you need a GFCI?
Electricity and water don’t mix. ifyour hair dryer falls into water o2 while the dryer is plugged in, the electric shock can kill you, EVEN IF THE SWITCH IS “OFF”,
Arugula fuse o circuit breaker won’t protect you under these circumstances. A GFCI offers you far greater protection.
AGFCI can save your life! Compared to that, the price is small! Don’t wait…Install one now!
- GFCl is a sensitive device which reacts immediately to a small electric current leak by stopping the electricity flow.
OPERATING INSTRUCTIONS
This appliance is intended for household use. Use on Alternating Current (60/50 Hz) only.
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will it in a polarized outlet onlly one way. If the plug does not fit ully in the outlet, reverse the plug. If it still does not fit, contact a qualified technician. Do not attempt to defeat this safety feature.
AUTO DUAL VOLTAGE
This appliance contains a special electronic circuit that automatically werts it for worldwide usage from 125/240V-~, 60/50Hz, 194/6.25A. Just plug t into the local current. You may need an adapter toallow the plug to fit into the local outlets.
When the appliance is plugged into a current that has a different voltage from the country of purchase, the Auto Dual Voltage icon will light up.
Note: Tool heat up time may vary based on country and voltage.
CHECK ALCI EVERY TIME YOU USE THIS HAIR DRYER
This hair dryer is equipped with an Appliance Leakage Circuit Interrupter (ALC), a safety feature that renders it inoperable under some abnormal conditions, such as immersion in water. To make sure the ALCI is functioning properly and the exclusive water sensing system (ALCI) is working, perform the following test:
-
Plug in the hair dryer and press the test button on the plug.
-
The hair dryer will stop working. There will be an audible click and the reset button will pop out.
-
To reset the ALCI with a Reset button: Unplug the unit. Then push the Reset button in, and reinsert
the plug into the outlet. -
Be sure to repeat the test every time you use this hair dryer to confirm the ALCI is operational.
-
If the ALCI is not functioning properly, return the hair dryer to a service center.
-
If a water immersion occurs, bring this unit into a service center. Do not try to reset.
should the dryer g0 off and the Reset button pop out during use, this could indicate a malfunction in the dryer. Remove the plug from the outlet and allow the dryer to cool. Reset the ALCI. Reinsert the plug into the outlet. The dryer should function normally. If not. return it to a service center for examination and repair.
OPERATING INSTRUCTIONS
HOW TO OPERATE
COOL SHOT
**HEAT SETTINGS
**
**POWER/SPEED SETTINGS
**
HOW TO USE YOUR
-
Attach the concentrator to dry hair evenly with a wide volume of air.
-
Select desired speed and heat levels. Fine and processed hair types should use the low heat setting Note: Circle indicator on each side of the switches indicates the selected setting.
-
Aiming the concentrator ina downward direction, rough dry hair until it is 80% dry.
-
Divide hair into 3-4 inch sections. Applying tension with around bristle brush, brush through each section while following with the dryer. To smooth the ends, slp the brush underneath the curve and blow over the curve.
-
Finish by pressing the Lock-in Cool Shot Button and applying cool air to your hair to set your style.
Lock-in Cool Shot Button
LOCK-IN COOL SHOT BUTTON
The Lock-in Cool Shot Button provides a burst of cool air to help set your style and seal in shine for a lasting finish.
To activate the cool shot. press and release the Lock-in Cool Shot Button
once. To deactivate it, press the button again.
Note: The Lock-in Cool Shot Button may remain activated after turning off the tool. If air is cool on next use, press and release the Lock-in Cool Shot Button once to deactivate it.
CONCENTRATOR ATTACHMENT INSTRUCTIONS
To attach, line up the arrows and snap the concentrator into place. To remove, line up the arrows, then hold the concentrator and snap it up or down to remove.
FILTER CLEANING INSTRUCTIONS
For optimal performance, clean your dryer rear filter. Simply brush or wipe away dust buildup with a soft cloth or small brush.
MAINTENANCE INSTRUCTIONS
- Make sure that the inlet and outlet grills are clear of dust and lint for proper operating performance.
- Your hair dryer is virtually maintenance free. No lubrication is needed.
- Always remove the plug from the outlet and allow the dryer to cool before cleaning.
- Use a soft cloth or a small brush to remove dust and lint that may have accumulated on the rear filter of the dryer.
- The hair dryer exterior may be wiped clean with a damp cloth,
- CAUTION: Never allow the power supply cord to be pulled, twisted or severely bent. Never wrap the cord tightly around the dryer. Damage will occur at the high flex point of entry into the hair dryer, causing it to rupture and short. Inspect the cord frequently for damage. Stop use immediately if damage is visible, if the unit stops or if it operates intermittently.
- If the cord or hair dryer is damaged or does not operate properly, return it to a service center for repair.
- This hair dryer has no user serviceable parts. Do not attempt to repair the appliance yourself.
STORAGE
When not in use, your hair dryer should be disconnected and stored in a safe, dry location, out of reach of children. Do not wrap the cord around the dryer. Allow the cord to hang o lie loose and straight at the point of entry into the hair dryer.
T3 LIMITED WARRANTY TERMS & CONDITIONS
3 Micro will repair o replace (at our option) T3 products for twenty four (24) months from the date of purchase if they are defective in workmanship or materials. This limited warranty does not cover (1) damage due to misuse or abuse, such as incorrect voltage supply. dropping, or falure to follow enclosed instructions or (2) tampering, such as repair or attempt to repair. To obtain service under this warranty, please visit www.T3Micro.com/warranty- info to submit awarranty claim, or call us at 866-376-8880 10 receive detailed instructions. You wil be required to provide proof of purchase.
THIS LIMITED WARRANTY IS ONLY VALID IF THE PRODUCT IS PURCHASED FROM AN AUTHORIZED SELLER OF T3 GOODS AND IF THE ORIGINAL SERIAL NUMBER ON THE PRODUCT HAS NOT BEEN REMOVED OR OTHERWISE TAMPERED WITH.
Any implied warranties, obligations, or liabilities, including but not imited
to the implied warranty of merchantability and fitness for a particular
purpose, shall be limited in duration to the 24 month
duration of this written limited warranty. Some states do not allow a
limitation on how long an implied warranty lasts, so the above imitation may
not apply to you.
IN NO EVENT SHALL T3 BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED.
Visit www.T3Micro.com/customer-service to complete your warranty registration.
SUPPLIER’S DECLARATION OF CONFORMITY 47 CFR § 2.1077 COMPLIANCE
INFORMATION
Model Name : T3 Afar
Model Description: Travel hair dryer with folding handle
Model Number: 76895, 76896, 76897, 76898, 76899
Responsible Party in USA: T3 Micro, Inc. 880 El Segundo Ca 90245
866.376.8850
Test Report Number: 210809160620-001
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver,
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
No change or modification to this equipment shall be made without the express written approval of the “responsible party” as defined in the FCC’s rules.
WARNING
D0 not use the appliance near ashore, bathtub, washbasin or other vessel fled with water. Never place the appliance in water or any other equid.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>