X4-LIFE 700403 4 in 1 Soil Tester Digital Soil Meter Instruction Manual

: June 30, 2024
: X4-LIFE

X4-LIFE 700403 4 in-1 Soil Tester Digital Soil Meter Instruction Manual

Specifications

Product Name: 4in1 Soil Tester Digital Soil Meter
Item No.: 700403
EAN: 4250679501780
Power Source: 9V block battery (6F22 / 6LR61)

Product Usage Instructions

Intended Use

The 4-in-1 soil tester is designed for determining the pH value, temperature, and moisture of the soil, as well as measuring light intensity for lawns, gardens, and potted plants. It is intended for household use only and not for commercial purposes.

Safety Instructions

Follow all safety guidelines provided in the manual.
Handle the device with care to prevent damage.
Ensure proper battery installation and handling.

Battery Installation

To install the battery

Open the battery compartment on the back of the device.
Connect the 9V block battery to the terminals with the correct polarity.
Insert the battery and close the compartment securely.

Battery Information

Avoid exposing the battery to extreme conditions to prevent hazards.
Replace damaged batteries promptly.
Remove the battery when not in use to prevent energy loss.
Dispose of used batteries properly according to regulations.

Technical Specifications

Measurement Modes: pH, Moisture, Temperature, Light Intensity
Measurement Range: pH 3.5 – 9.0, Moisture (5 stages), Temperature in Celsius or Fahrenheit

4in1 Soil Tester digital Soil Meter

Item No. 700403 EAN: 4250679501780
This operating manual should be read carefully before initial use as it contains instructions for safe use and disposal of the product. Please strictly adhere to the instructions in the operating manual when using the product. The operating manual and packaging should be retained as parts of the product and handed over to third parties when passing on the product.

Intended Use

This 4-in-1 soil tester is used to determine the pH value, temperature, and moisture of the soil, as well as to measure the light intensity at the planting site for lawns, garden, and potted plants. Any other use is not intended. This product is not intended for commercial use and should only be used in private households.

Safety Instructions

Despite stable construction, residual risks exist as with all electrical and electronic devices. The following safety and hazard instructions serve not only to protect the device but also your health.
For safety and certification reasons (CE), modification and/or alteration of the device are not permitted. Never disassemble the device.
If you have doubts about the operation, connection, or safety, consult a professional or the manufacturer.

CAUTION! Hazards for children! This product is not a toy. Keep the device out of the reach of children and pets. Do not leave the packaging material lying around.
CAUTION! Risk of suffocation and swallowing due to swallowable small parts!
DANGER! Risk of fire. Keep the product away from open flames or strong heat sources. Do not place near flammable materials or easily flammable objects. Avoid extreme heat or cold.
CAUTION! Avoid direct contact with water or other liquids. Immersion of the device or probe into liquids can cause damage or device failure.
CAUTION! Do not apply excessive force when using the device. The probe may bend or break if pressed too hard into the ground.

Battery Installation

Please observe the battery safety instructions! Carefully open the battery compartment on the back of the housing. Connect the 9V block battery (6F22 / 6LR61) to the terminals, ensuring the correct polarity. Insert the battery into the battery compartment and close it until the cover audibly clicks into place.

Battery Information

Protect the battery from extreme heat, fire, direct sunlight, and short circuits to avoid explosion hazards and damage.
Replace damaged or leaking batteries immediately. Remove the battery from the device when not in use to prevent energy loss or damage.
Keep batteries out of the reach of children or persons who cannot assess the hazards.
Dispose of used batteries by local regulations.

Technical Specifications

Weight: approx. 73 g (without battery)
Power supply: 9V block battery
Type: 6F22/6LR61
Operating temperature: + 5°C to + 40°C
Storage temperature: – 10°C to + 50°C
Dimensions: 63 x 315 x 36 mm
Probe length: 20 cm
Temperature display: °C/°F

Scope of Delivery

Soil tester, 1x block battery, operating manual

The Device

Before the first measurement, remove the protective film from the display and the protective cap from the probe. The device will automatically shut off if no button is pressed for approximately 4 minutes. Press and hold the °C/°F OFF button for about 3 seconds to manually turn off the device.

X4-LIFE-700403-4-in-1-Soil-Tester-Digital-Soil-Meter-Instruction-Manual-
FIG-2

Measurement

General measurement instructions

Carefully clean the end of the measuring rod before each measurement.
Insert the measuring rod straight into the ground. Do not apply force. If you encounter resistance, try another spot.
The rod must be positioned centrally between the plant stem and the edge of the flower pot. For large pots with a diameter of more than 30.5 cm (approx. 12 inches), place the measuring rod so that it is at 1/3 of the distance to the pot rim from the plant stem.
If the flower pot is particularly deep, insert the measuring rod deep into the soil until it is among the roots.
Temperature and humidity are measured simultaneously.
Press the probe gently into the soil to avoid damaging the probe.

Measurement of light intensity

Light intensity measurement range: 9 levels (LOW to HGH+)

Increase in quantity and quality of light

If the measured light intensity is higher/lower than the recommendation, move the plant to a place with less/more sun.

Place the device in the soil so that the light sensor faces the direction of the strongest light. Turn on the device with the ON button. The light intensity will be displayed on the screen. Compare the measurement result with the recommendations in the plant table (Chapter „Plant Table“).

Measurement of soil pH value

pH value measurement range: 12 steps (3.5 to 9.0; display resolution: 0.5)
LO and HH = the measurement result is outside the measurement range
If the measured pH value is higher than the recommendation, add some granite meal, sulfur powder, or peat into the soil.

If the measured pH value is lower than the recommendation, add some lime into the soil.
The amount of acid or alkali in the soil is measured by the „pH value.

A high concentration of acid slows down the beneficial work of bacteria in the soil.
Excess alkali in the soil reduces nutrient content and increases salt concentration, inhibiting plant growth.

Set the measurement mode to pH.
Insert the probe into the soil.
Turn on the device with the ON button. The device begins measuring.
You can read the measurement result on the display after some time. Leave the device in the soil for a more accurate result.
Compare the measurement result with the recommendations in the plant table.
If the tested soil is extremely dry or nutrient-rich and the pH value cannot be tested, the user should sprinkle some water into the soil. Test again after half an hour.\

Soil Moisture Measurement

Set the measurement mode to °C.
Insert the probe into the soil.
Turn on the device with the ON button.
You can read the measurement result on the display after some time. Leave the device in the soil for a more accurate result.
Compare the measurement result with the recommendations in the plant table.

Increase in water content

Moisture range: 5 levels (Very Dry, Dry, Normal, Wet, Very Wet)
Water content at the test site:
DRY under 10% | NOR 10% to 20% | WET over 20%

If the measured moisture is lower than recommended, water the plant until the recommended range is reached.
If the measured moisture is higher than recommended, stop watering until the recommended range is reached.

Soil Temperature Measurement

Temperature measurement range:

9°C to +50°C/16°F to 122°F
Set the measurement mode to °C.
Insert the probe into the soil.
Turn on the device with the ON button.
You can read the measurement result on the display. If the device is not in the soil, the ambient temperature will be displayed.

You can switch between Celsius and Fahrenheit units using the °C/°F OFF button.

Cleaning and Care

The product can be easily cleaned with a damp cloth. Caustic cleaning agents or scouring pads should not be used as they may damage the
product. Never clean the product under running water, as this will render the product unusable.
NOTES: Remove the device from the ground after measuring. Do not use the device in environments with high humidity. Do not leave the device outdoors, but store it in a dry indoor area.
10. Packaging
Ensure proper disposal of packaging materials. Inquire about collection points or waste separation with your local authorities.

Disposal

If the product contains batteries, it is important to remove them before disposal. Proceed as follows: 1. Carefully open the battery compartment. 2. Remove the battery from the product.
The crossed-out wheeled bin symbol on electrical devices, and the same symbol without a bar on batteries and rechargeable batteries, are there to remind you to properly separate your waste.

According to the guidelines 2012/19/EU and 2023/1542/EU, electrical waste may not be disposed of in unsorted municipal waste, as it contains hazardous substances and can potentially have negative impacts on health and the environment. You are legally obligated to return these devices to an approved collection point, such as a recycling center or retailer that must accept them. This helps ensure that the devices are reused, recycled, or otherwise utilized. The return is free of charge for you. Your local waste disposal company will inform you of the collection point for electronic devices. V

Batteries and rechargeable batteries may not be disposed of in household waste! Every consumer is legally obligated to return all batteries and rechargeable batteries, regardless of whether they contain hazardous substances (Cd= Cadmium; Hg= Mercury; Pb= Lead) or not, to a municipal or retail collection point, so that they can be disposed of in a environmentally friendly manner. The disposal of batteries is free of charge.

Warranty Conditions

2-year manufacturer‘s warranty on material and manufacturing defects.
These warranty conditions apply to customers in Germany and EU countries.
For customers outside of Germany, the buyer must bear the return shipping costs until we receive the defective goods.
Proof of warranty through the purchase receipt. Free rectification of material or manufacturing defects during the warranty period.
No extension of the warranty period through warranty service.

Warranty Exclusions

In case of damages resulting from improper operation.

For wear parts/accessories that are subject to normal wear and tear.
For defects that were known to the customer at the time of purchase.
For damages resulting from repair or intervention by the buyer or unauthorized third parties.
If the device is connected to a power supply with a higher voltage than specified on the device.
If the device or individual parts are dropped.
In case of improper transport or improper packaging for transport.
For damages caused by force majeure.
If the safety precautions applicable to the device are not observed.
Battery/rechargeable battery is not covered by the warranty.

Return Conditions

In the event of a justified warranty claim, we reserve the right, at our discretion, to repair or replace the defective device free of charge. Replaced parts or products become our property. We reserve the right to replace defective parts or products with successor models.
No further claims shall exist.
If a return has been agreed upon, send the device securely packaged at your expense to our service department. Be sure to include a copy of the proof of purchase.
Please always contact us first before sending your product to us.
Repairs incurred after the warranty period has expired are subject to a fee. Shipments sent without prepayment cannot be accepted and will automatically be returned.

Conformity Declaration

This product complies with national, legal, and European requirements. The conformity declaration for this product can be found at: http://productip.com/?f=52e1d

Service Adressed

Friedrich-Seele-Straße 20
DE-38122 Braunschweig
+49 (0) 531 224356-81
info@lived-non-food.de

Manufacturer

Lived nonfood GmbH
Friedrich-Seele-Straße 20
DE-38122 Braunschweig
www.lived-non-food.de