6 SIGMA SIM RACING 6S-160 Racing Chassis Instruction Manual
- June 29, 2024
- 6 SIGMA SIM RACING
Table of Contents
6 SIGMA SIM RACING 6S-160 Racing Chassis
Specifications
- Dimensions: 2 x 40-160-1370 mm, 2 x 40-120-780 mm, 2 x 40-160-500 mm, 3 x 40-80-480 mm, 2 x 40-40-500 mm
Product Usage Instructions
Notes:
- Safety First: Be mindful of sharp edges. Use safety goggles when removing tabs from angle brackets.
- Protect From Scratches: Use a towel or blanket on hard surfaces to prevent damage to aluminum extrusions.
- How to Measure Screws: Flat head screws are measured by overall length, socket head cap screws by length under the head.
- Metric Conversions: Various metric measurements converted to inches.
T-Nut Installation
Plan the order of T-nut installation and align tabs properly.
Alignment Tab Removal
If tabs interfere with extrusion installation, remove as necessary.
Step-by-Step Assembly
Step 1:
- Use 20-40×40 angle
- Insert 40-M8 T-Nut and 40-M8x16 screws
Step 2:
- Use 2-40x160x500 components
Step 3:
- Utilize 2-40x160x1370 components along with the foot pad and M14/M13 parts
FAQ:
Q: What should I do if I encounter sharp edges during assembly?
A: Use safety goggles and handle with care to avoid injuries.
Assembly Documentation
(Shown with optional 6 SIGMA label plate.)
(Shown with optional shifter mount and mouse pad kit.)
Need help? Email: info@6sigmasimracing.com Toll-free: 1-888-608-6161
PARTS
NOTES
Safety First
Be mindful of any sharp edges. Use safety goggles whenever removing tabs from angle brackets.
Protect From Scratches
Hard surfaces can damage the surfaces of the aluminum extrusions.
Use a towel or blanket when assembing on hard surfaces to protect the
finishes.
How to measure screws
Flat head screws are measured based on their overall length.
Socket head cap screws are measured based on the length under the head of the
screw.
Metric Conversions
- 25.4 mm = 1″
- 16 mm = 5/8″
- 20 mm = 25/32″
- 400 mm = 15 3/4″
- 420 mm = 16 1/2″
- 500 mm = 19 11/16″
- 580 mm = 22 13/16″
- 750 mm = 29 17/32″
- 1200 mm = 47 1/4″
T-Nut Installation
Be mindful of the order of installation and plan out the insertion of T-nuts.
Alignment Tab Removal
Tabs on brackets may need to be removed if they interfere with the
installation of an extrusion as shown to the right.
2 – tabs need to be removed from 4 brackets
NOTE:
Leave screws loose enough to slide the T-Nuts into the aluminum extrusion
profiles.
SHIFTER MOUNT AND MOUSE PAD KIT (OPTIONAL)
Need help? Email: info@6sigmasimracing.com Toll-free: 1-888-608-6161
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>