MagSafe TYLT Bell Speaker Instruction Manual
- June 29, 2024
- Magsafe
Table of Contents
MagSafe TYLT Bell Speaker
POWER BUTTON
- Hold the power button for 3 seconds to turn the unit on/off
- Touch the power button to answer /end the call
LIGHT INDICATION
- Solid White – Charging
- Battery Blinking Blue – Pairing Mode
- Solid Blue – Connected
- Power on/off and pairing button
- Light indication
- USB-C input
- 2W MagSafe compatible Bluetooth” speaker and stand
- 500 mAh rechargeable battery
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
NOTE 1
This equipment has been tested and found to comply with the limits for a
Class B digital device, under part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used by the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
NOTE 2
Any changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.