MagSafe V16 3 in 1 Wireless Charger User Guide
- June 12, 2024
- Magsafe
Table of Contents
MagSafe V16 3 in 1 Wireless Charger User Guide
Thank you for purchasing and using this product!
Please read this operation instruction carefully before using this product
Product Specification
3in 1 MagSafe Charger
- + Input: SVE2A/OV=2A
- Cell Phone Output: 5W/7.5W/10W/15W
- Apple Watch Output: 3W
- AirPods Output: 5W
- Charging Efficiency: 70%
Applicable Devices
iPhone | iPhone 14 /13 /12 Series |
---|---|
AirPods | AirPods Pro 2 / AirPods Pro. |
Apple Watch | Apple Watch Ultra, SE, 82 |
The listis of known existing models and will be compatible with subsequent new models.
Blinking white LED light during wireless charging| toindicate charging failure.
‘The following situation can cause failures, like charging slowly, stop charging, over-temperatue for charging positon.
- The adapter is not runup o standard (No PC USB output power supply)
- The charging cable is not up to standard.
- The phone case is too thick ( within 2mm thickness phone case recommended )
- The buitin wireless charging receiver position is not coincided with wireless charger coil position There is metal/magnet on the back of cell phone or phone case.
- Smariphone does not support wireless charging function.
ATTENTION
- Please keep the charger away from water or other liquid
- If you need to clean the charger, please make sure it is not connected to power supply.
- Operating temperature: ~20-45T
Product Description
- 3in 1 Magsafe Charger, a wireless charging stand solves the charging of 3 devices.
- Folding design, easy to carry when traveling,
Input
Connect the wireless charger and adapter with the charging cable.
Please use a PD/QC3.0adapter 5o that the charging will enter the fast charging mode.
LED indicator light
White LED: StandBy
Blue LED light: Normal charging,
Blinking white LED light: Abnormal charging.
Magsafe Usage
Non-case
Apple MagSafecase
Other MagSafe case
Thick case
Normal case
Metal
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’ s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna. – Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body. This transmitter
must not be co-located or operating in conjunction with any other antenna or
transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>