accurasee mechanical Wall, Ceiling Mounting Instructions
- June 28, 2024
- accurasee mechanical
Table of Contents
Wall, Ceiling Mounting
“`html
Product Specifications
-
Mounting Options: Wall, Ceiling, Table, Floor
-
Installation: Requires drilling for wall/ceiling mount; fabric
seal for non-drilling option -
Compatibility: Suitable for windows, doors, and sturdy
walls/ceilings -
Dimensions: Length of window or door: 4 inches
Product Usage Instructions
Wall/Ceiling Mount
-
Locate the back of the product and mark the holes/slots of each
bracket on the wall/ceiling using a pencil. -
Attach hooks or nails to the marked points for support.
-
Affix the product securely to the wall or ceiling ensuring it
is stable.
Fabric Seal Installation
To avoid drilling, follow these steps:
-
Use a fabric seal with 2 zipper orifices.
-
For windows/doors, firmly seal the board(s) or fabric
material(s) to the edges of the window/door. -
For wall/ceiling installation, ensure the surface is sturdy
enough to hold the product securely.
Important Note
Please read the user manual thoroughly before installing and
operating the product to ensure safety and proper usage.
Frequently Asked Questions (FAQ)
Q: Can this product be used on sliding windows?
A: The product may not be suitable for sliding windows due to
its mounting requirements. It is recommended for casement or
non-sliding windows.
Q: What should I do if I encounter difficulties during
installation?
A: If you face challenges during installation, refer back to the
user manual for troubleshooting tips. You may also seek assistance
from customer support for further guidance.
“`
INSTALLATION GUIDE 2024v10x
1
Mount the product on a wall / ceiling. You may also place it on a table / floor.
A
Wall / Ceiling Mount
Fasten 4× brackets to the
back of the product (see A).
Use a pencil to mark the
hole or slot of each bracket
on the wall or ceiling (see B).
Attach hooks or nails to
the marked points.
Affix the product to the
wall or ceiling.
B
1
Courtesy of Oliver E., Tibor K., F.G., and J. R. for copyright of certain images.
INSTALLATION GUIDE 2024v10x
2
Drill 2× 3-inch (~76 mm) diameter holes.
To avoid drilling, use a fabric seal that has 2 zipper orifices.
FABRIC SEAL
Window / Door
· Make a board by cutting a piece of wood, plastic, rigid insulation sheet, or
Kraft board to at least 4-inch (~102 mm) in width. You may also buy an off-
the-shelf vent board.
· Drill 2 holes into one board or 1 hole each into two boards. · Attach the
board(s) to a section of a window / door. · Alternatively, a fabric seal can
be attached to the edges of the window / door.
It may be the best option for a casement or non-sliding window.
The board(s) or fabric material(s) shall be firmly sealed to the edges of the
window / door.
Wall / Ceiling
· Drill 2 holes into the wall / ceiling.
The wall or ceiling shall be sufficiently sturdy to install the product.
BOARD BOARD
Length of your window or door
4 in
2 Note. You may need to add clearance to the diameter of the holes. The holes shall be at least 1 ft (~305 mm) apart and can be up to 5 ft or more as per ASHRAE Standard 62.1 2019.
INSTALLATION GUIDE 2024v10x
3
Insert 2× ducts into the holes and supply power to the product. Ensure that the zippers are fastened if a fabric seal is used.
Note. Please read the user manual before installing and/or operating the product.
3