accurasee mechanical V9XX Portable Heat Recovery Ventilator Installation Guide

: June 15, 2024
: accurasee mechanical

Table of Contents

accurasee mechanical V9XX Portable Heat Recovery Ventilator
Product Information
Product Usage Instructions
Fabric Seal
FAQ
Using Instructions
Window / Door
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

accurasee mechanical V9XX Portable Heat Recovery Ventilator

Product Information

Specifications

Mounting: Wall / Ceiling or Table / Floor
Window/Door Compatibility: Casement or Non-sliding windows
Board Length: 4 inches

Product Usage Instructions

Mounting Options

The product can be mounted in two ways:

Wall / Ceiling Mount: Ensure that the wall or ceiling is sturdy enough to support the product. Follow the instructions provided in the user manual for proper installation.
Table / Floor Placement: Simply place the product on a table or the floor.

Fabric Seal

If you have a casement or non-sliding window, using the fabric seal may be the best option. Follow the steps below:

Measure the length of your window or door.
Cut the fabric material according to the measured length.
Firmly seal the fabric material to the edges of the window or door.

FAQ

Q: What should I do before installing and operating the product?
A: Please read the user manual thoroughly to familiarize yourself with the installation and operation instructions.

Using Instructions

Mount the product on a wall/ceiling.
You may also place it on a table/floor.

accurasee-mechanical-V9XX-Portable-Heat-Recovery-Ventilator-
FIG-1

Drill 2× 3-inch (~76 mm) diameter holes.
To avoid drilling, use a fabric seal that has 2 zipper orifices.

Window / Door

Make a board by cutting a piece of wood or plastic or rigid insulation sheet to at least 4 inches (~102 mm) in width. You may also buy an off-the-shelf vent board.
Drill 2 holes into one board or 1 hole each into two boards.
Attach the board(s) to a section of a window/door.
Alternatively, a fabric seal can be attached to the edges of the window/door.
It may be the best option for a casement or non-sliding window.
The board(s) or fabric material(s) shall be firmly sealed to the edges of the window/door.

Wall / Ceiling

Drill 2 holes into the wall/ceiling.
The wall or ceiling shall be sufficiently sturdy to install the product.

Note. You may need to add clearance to the diameter of the holes. The holes shall be at least 1 ft (~305 mm) apart and can be up to 5 ft or more as per ASHRAE Standard 62.1 – 2019.