PHILIPS PPM6501 Foot Spa Massage User Guide

Foot Massager
Foot Spa Massager
PPM6501 Quick Start Guide

Installation

1. If the support holders have been installed on the massager: unfold the support holders and place it on the ground, and remove the dust cover. While lifting the handle, press the massage turntable down until the massager unfolds normally.
2. If the support holders are not installed on the msaasger: remove the dust cover and place the massager flat on the ground. While pressing one side of the massage turntable, lift the upper edge of the massager on the same side and lift it up to expand the massager to a certain angle; repeat the above on the other side to fully expand the massager. Then install the support holders according to the prompts on the massager.

Add water and power on

Place the massager on a flat surface, add an appropriate amount of water (it is recommended to add warm water at about 35°C to reduce waiting time), and connect to a 220-240V~/50-60Hz household power supply. After power on, the buzzer makes three beeps, the indicator light in the massager flashes slowly, and massager enters the standby state.

Turn on the device and switch levels

1. In standby state, hold the power button for 2 seconds to start the massager in Level I (40°C); press the power button again to switch to Level II (43°C); and then press the power button again to switch to Level III (46°C). Press the button to cycle through the three levels in sequence. When the water temperature reaches the specified temperature, the massage function will automatically turn on, and end after 30 minutes.

Turn off the device

In any working mode, hold the power button for 2 seconds, the buzzer will sound for 1.5 seconds, and then end the current mode and enter the standby state.

Use the remote control

After power on, aim the remote control into the massager and press button. The buzzer sounds once, the indicator light in the massager displays in green, and the massager turns on Level I; In any working state, aim the remote control into the massager and press button, and the massager will switch to the corresponding levels. In any working state, aim the remote control into the massager and press button to turn on / off the massage function; In any working state, aim the remote control into the massager and press button. The buzzer sounds for 1.5 seconds, and then end the current mode and enter the standby state.

Storage

1. Pour out the water in the massager and let it dry;

2. Place the massager upside down on the ground with a soft carpet;

3. Press down on both sides of the massager bottom shell at the same time to fold it;

4. Pull gently the support holders inward to fold it close to the bottom shell;

5. Put the massager upwards with the dust cover, put the remote control in place, and the storage is complete.

6. It is recommended that do not add water exceeding 46°C to prevent scalding feet. For your safety, when the water temperature exceeds 50°C, the device stops heating, accompanied by 10 warning sounds, and the indicator light flashes red 10 times and then it enters shutdown state. After the water temperature drops below 48°C, the device enters standby mode.

7. It is recommended to drink a 250ml cup of warm water before and after use.

8. In general, the foot spa for 30 to 40 minutes is better. Please drink the appropriate amount of warm water during use.

9. Every Philips foot massager is qualified in strict water testing before delivery. It is normal for any residual water stains in the product that you receive. Please feel free to use it.

Visit us www.philips.com
There may be certain differences between the content of this manual and your product. Please refer to the actual product. We reserve the right to update the product at any time without prior notice.
© 2023 AquaShield
All rights reserved
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license.
This product has been manufactured by and is sold under the responsibility of Guangdong Deerma Technology Company Limited and Guangdong Deerma Technology Company Limited is the warrantor in relation to this product.

Made in China
Rev A SEP 23

Documents / Resources

| PHILIPS PPM6501 Foot Spa Massage [pdf] User Guide
PPM6501 Foot Spa Massage, PPM6501, Foot Spa Massage, Spa Massage, Massage
---|---
| PHILIPS PPM6501 Foot Spa Massage [pdf] Instruction Manual
PPM6501, PPM6501 Foot Spa Massage, PPM6501, Foot Spa Massage, Spa Massage, Massage

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>