User Manual

Thank you for buying the PISEN 45W GaN Desktop MagStation Charger. Please read this manual carefully to ensure safe and satisfactory operation, and properly keep it for future reference.

(3.5+2.28+2.28in)
Net Weight| Approx. 410g (14.46oz)
Working Temperature|
Accessories| Charger *1

Power Card * 1

Type-C Charging cable+1

User Manual +1

Products Appearance

Warning

• Don’t expose to liquids.
• Don’t Disassemble
• Avoid Dropping
• Avoid Extreme Temperatures
• Not a toy. Keep out of reach of children.
• In case of broken cards or plugs, the product must be disposed of.
• Disposed of the product as per local law and regulations.
• If you want to clean product. Please use only dry cloth or brush.

To comply with the published safety standards, the following must be observed when using this power supply.

• Minimum ambient temperature wound the power supply most not exceed 25 deg C
• The output power taken from the supply must not exceed the rating given on the “Power Supply”
• The power sappy is approved and certified for the rated voltage range 100-240 Vac.
• The disconnection from the line voltage is made by AC plug.
• The Unit can be used together with and information technology product.
• The power supply is not intended to be repaired by service personal in the case failure or component defect (unit can be thrown away).

Design By Risen Made in China
Manufacturer GUANGDONG PISEN ELECTRONIC: CO. LTD
Address Balding 5. 1st Floor. No 9. Qinfu 1st
Street, Liuyue Nan Community, Nenggang Town,
Longgang District, Shenzhen City, Guangdong
Province. China

PISEN The brand belongs to GUANGDONG PISEN ELECTRONICS CO. LTD.
For FAQs and more help information. please visit https://en.pisengroup.com
Contact: support@pisengroup.com

FCC Statement

This device complies with part 15 of the FCC rules. Operation is subject to the following two cond itions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions , may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help important announcement

Radiation Exposure Statement

The FCC certification of this device refers to RF exposure testing performed in typical operating conditions, where a personas no closer than 20 centimeters from the device surface at all times, except for non-repetitive palters with transient time intervals in the order of a second. Only in the stated conditions, the device is shown to fully comply with the FCC RF Exposure requirements of KDB 447498.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>