ausclimate AU-1910DD Premium 10L Desiccant Dehumidifier User Manual

: June 26, 2024
: ausclimate

Table of Contents

ausclimate AU-1910DD Premium 10L Desiccant Dehumidifier
FEATURES
PRODUCT DESCRIPTION
THE CONTROL PANEL
UNIT SETUP
TO OPERATE SAFELY
OPERATING INSTRUCTIONS
TO EMPTY THE WATER BUCKET
TO DRAIN WATER
MAINTENANCE
TROUBLESHOOTING
SPECIFICATIONS
TWO YEAR WARRANTY
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ausclimate AU-1910DD Premium 10L Desiccant Dehumidifier

WARNING

PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING.

WARNING – This appliance is intended for use in a domestic or office environment only. Any other use is not recommended by the manufacturer and may cause fire, electrical shocks or other injury to person or property.
When using electrical appliances, basic safety precautions should always be followed

Do not operate the unit with a damaged power supply cord or power plug, or after it malfunctions or has been dropped or damaged in any way. If the supply cord or plug is damaged, it must be replaced by the manufacturer, the distributor, its service agent or similarly authorised qualified persons in order to avoid a hazard.
This unit should always be kept in an upright position to avoid any damage. Place the unit on a flat stable surface.
Check the household voltage to ensure it matches the unit’s rated specification before operating.
Operate this unit in an ambient temperature between 1°C and 40°C.
Ensure that the air inlets and outlets are not blocked or covered.
Do not place the unit too close to curtains or other furnishings – min 20cm.
When using the “LAUNDRY MODE” to speed up the drying of wet clothes in the room, please keep the clothing at a safe distance from the unit to prevent water from dripping onto the unit.
Never place anything on top of the unit and do not cover with any kind of material while in use.
This product is intended for domestic, and office use ONLY and not for commercial, industrial or outdoor use.
To protect against electrical shocks, do not immerse unit, power cord or power plug in water, or spray with liquids.
Never unplug the power cord without pressing the “ON/OFF” key to “OFF” first, as this could damage the unit.
Always unplug the unit when not in use or moving it to a new location. To disconnect from the power supply, grip the plug to pull from the power socket. Never pull by the cord.
Always empty the water tank before storing the unit away.
Close supervision is necessary when any appliance is used near children and pets.
Do not run power cord under carpet or cover the power cord with rugs or runners. Arrange the power cord away from areas where it may be tripped over.
Never operate or store the unit in direct sunlight.
If authorised by the distributor, repairs may be undertaken by a qualified service technician. Repairs carried out by unqualified people may cause damage to the unit, damage to property or injury to persons and void the warranty.
Where possible, don’t use an extension power lead as the cable may overheat and cause a risk of fire. Only use an extension lead after ensuring it is in perfect condition.
Do not use the unit without the air filter and make sure that the filter is kept clean to avoid malfunction and invalidating the warranty.

WARNING
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.

SAVE AND READ THESE IMPORTANT SAFETY INSTRUCTIONS

FEATURES

(Non) Compressor dehumidifier ~ uses desiccant rotor technology
Environmentally friendly with no harmful gasses & quiet operation
Moisture removal ~ 10 litres/day (20 C, 60% RH)
Water tank capacity ~ 3 litres
Nano-silver embedded in the air filter ~ kills bacteria on contact improving the quality of air in your home or office ~ Anti-bacterial nano-silver embedded in each filter string~ Over 99% anti-bacteria performance~ The filter may be cleaned by use of a vacuum cleaner ~ The filter may also be washed by water and still retain performance
Laundry mode ~ includes power saving setting for warm temperatures & turbo setting for winter
Up to 12-hour timer ~ for added convenience
Temperature range for use ~ 1 C – 40 C
Light & portable with carry handle
Removable water bucket with handle
Auto restart after power cut ~ Once the power is restored after a power failure, the appliance will continue to operate at the selected settings prior to the power failure.
Automatic louver wide range (max 150°)~ 3-stage automatic air swing to meet your needs.

PRODUCT DESCRIPTION

THE CONTROL PANEL

UNIT SETUP

Place the unit in an upright position on a stable, flat surface.
Ensure the unit is a safe distance away from a wall or furniture (see the right graphic).
Keep clothes at a safe distance from air outlet of the unit and prevent water dripping into the unit.
Where to position your dehumidifier? For best results position the dehumidifier somewhere central, such as the middle of the room or a hallway. Do not position in front of a radiator or in direct sunlight.

TO OPERATE SAFELY

OPERATING INSTRUCTIONS

ON and OFF

Connect the power plug to the appropriate electrical socket outlet.
Press the ON/OFF button to turn the unit ON.
Press the ON/OFF button again to turn the unit OFF.
Note : In the event of a power failure
Once the power is restored after a power failure, the unit will continue to operate at the selected settings prior to the power failure. This includes the drying mode, swing function and time remaining in timer mode.
Note : After turning the appliance OFF
After turning the unit OFF using the ON/OFF button, the fan will continue to run for a two-minute period. This is a normal procedure and helps to cool & protect the internal components.
During this two-minute period, DO NOT remove the power plug from the power socket outlet; wait for the fan to stop running.

DRY MODE

Press the “DRY MODE” key for dehumidification (general drying of your home or office).

AUTO itself is not a fan speed but a target relative humidity set point that uses either the low or high fan speeds to reach its target of 50-55%RH.If the relative humidity of the room is close to or within this range, then switching between LOW and AUTO will make no difference to the fan speed.

LAUNDRY MODE

Press the “LAUNDRY MODE” key for drying clothes.

AUTO SWING LOUVER
Press the “SWING” Key to select the preferred air louver angle.

The louver modes are useful for speeding up the drying of washing, wardrobes and walls because it directs the airflow towards the surface of these areas – water molecules will be forced out faster.

TIMER

Press the “TIMER ” key to select your desired running time (2, 4 ,8 or 12 hours). The unit will automatically switch off at the end of the selected time period.As the time counts down the LED lights (8, 4 or 2 hours) will indicate the time remaining.
When no “TIMER” is set (the LED light is off), the unit will run continuously unless the bucket is already full.

The Timer mode is useful if you want to dry a load of washing in ‘Turbo’ laundry mode and you know that it will take say, 4 hours and you wish to just run the unit at full power for that time period.

TO EMPTY THE WATER BUCKET

When the water bucket is full, the “FULL” LED lights up and the unit stops ina few minutes.
Do not move the unit or remove the water bucket if the machine is still operating. Water may leak and cause damage to the unit or cause an electric shock.
To remove the water bucket, pull it out by gripping the bottom of the bucket, and lift carefully.
Remove the cover of water bucket first, then pour the water away. Clean the bucket and return the cover and the bucket to the correct position.

Clean the water bucket with clean water if needed.
Do not use solvents, abrasive materials or hot water.
Do not remove or damage the float in the bucket, or the unit cannot work correctly.
The bucket cover must be correctly fitted into position.
The “FULL” LED lights up if the bucket is not correctly fitted into position.

TO DRAIN WATER

You may use 2 methods to remove the collected water: water bucket or drain hose.
A drain hose with an inner diameter of 12mm is quite suitable for continuous drainage (1.2M drain hose is included):

Use a screwdriver to remove the ‘knockout’ at the back of the unit. Attach the tubing to the connector through the hole.
The drain hose should lead downwards away from the unit, with no sharp bends to ensure uninterrupted drainage.

MAINTENANCE

Cleaning the unit

Turn off the unit, wait for the fan to stop and unplug from the power socket.
Clean the surface with a soft damp cloth.
Dry thoroughly with a towel after cleaning.
To avoid damage, do not wash or splash the unit with water, or let water drip into the air inlet or air outlet.

Cleaning the nano-silver air filter

If the filter is covered with dust, the airflow and the performance of the unit will be affected. It is recommended to check and clean the pre-filter every month or as required.

1. Turn off the unit and remove the filter from the unit.
2. The pre-filter can be washed and wiped gently.
3. Replace the filter in position.

Before placing in storage

Turn off the unit, wait for it to stop and unplug from the power socket.
Clean and dry the bucket, as well as the filter and the rest of the unit.
Clean the filter and the unit. Cover the unit to prevent it from gathering dust.
Store upright in a cool dry place.
Do not expose to direct sunlight.

TROUBLESHOOTING

Check the following before contacting technical support

SPECIFICATIONS

Figures noted, in the contents are for reference only; variation may result due to application in different countries or regions and shall be based on the best of practical operation.

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check your local authority of retailer for recycling advice.

TWO YEAR WARRANTY

Thank you for purchasing this Ausclimate product. Your product is warranted against faults and manufacture when used in normal domestic use for a period of two years. In non-domestic use Ausclimate limits the voluntary warranty to three months.
Ausclimate undertake to repair or replace this product at no charge if found to be defective due to a manufacturing fault during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried out by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act (1993).

Ausclimate – New Zealand CDB Media Ltd.