myzone W888 MZ-Switch Heart Rate Monitor User Guide
- June 6, 2024
- myzone
Table of Contents
myzone W888 MZ-Switch Heart Rate Monitor
Connect
On your wrisUarm – Press and hold thee button. You should hear a long beep and see the LED light flashing. The LED light changes color with your pulse to show your Effort Zone. Hold the fit button and listen for the three beeps to turn the MZ-Switch off.
On your chest – The MZ-Switch turns on when it senses your heart rate, but the
LED won’t flash. Moisten the black pads on the chest strap for better
connectivity. To switch off, remove the strap from the chest and listen for
the three beeps.
Once you connect, watch your stats stream to the live display at your gym. If
you are outside of the gym, view the Workout screen in the Myzone app, as long
as you’re connected to the internet and have your Bluetooth and Location
Services enabled. If you see it on the screen, it’s saved to your account.
Setup
Download the Myzone app and register your MZ-Switch. Already have an account?
Simply replace your MZ-Switch serial number in the app. 61ME!if.W
Wearable Three Ways
On your wrisUarm
Accurate for lower-intensity physical activity such as swimming, walking,
jogging and cycling.
Press the MZ-Switch into the wrist/arm strap, slide on and tighten against
your skin.
On your chest
Suitable for every type of exercise except swimming. Press the MZ-Switch onto
the chest strap and place over your sternum. You’ll hear a single beep when it
picks up your heart rate. Moisten the black pads on the chest strap if you
don’t hear a beep right away. .
Switch
Switch it up easily. Simply release the Myzone module from the MZ-Switch wrist/ arm cradle and button it onto the chest strap (or vice versa).
Charge
Your MZ-Switch comes fully charged and should last up to 6 months. You can charge your MZ-Switch with the USB charging cable provided in any power adaptor that is 5 volts or less. Do not charge Myzone products with a 9-volt charger.
Battery life:
- Pulsing red = low battery
- Pulsing green = fully charged
- You will receive a notification when
- you have less than 20% battery charge remaining. The battery level is also visible on the app Workout screen whenever the device is active.
To discover more about your MZ-Switch, go to myzone.org
FCC compliance statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of th e FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>