audio pro P5 Waterproof Bluetooth Speaker User Manual
- June 3, 2024
- audio pro
Table of Contents
audio pro P5 Waterproof Bluetooth Speaker
© AUDIO PRO AB, SWEDEN. ALL RIGHTS RESERVED.
TRADEMARKS ARE THE PROPERTY OF AUDIO PRO AB, SWEDEN.
Audio Pro AB, Garnisonsgatan 52 SE-254 66 Helsingborg, Sweden
©1978-2020 Audio Pro AB Sweden. Audio Pro®, the Audio Pro logotype, the ‘a’
symbol, and ace-bass® are all registered trademarks of Audio Pro AB, Sweden.
All rights reserved. Audio Pro follows a policy of continuous advancement in
development. Specifications may be changed without notice.
All other products and services mentioned may be trademarks or service marks
of their respective owners.
THIS DOCUMENT CONTAINS INFORMATION THAT IS SUBJECT TO CHANGE WITHOUT NOTICE.
Bluetooth
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by AUDIO PRO AB, is under license. Other trademarks and trade names are those of thier respective owners.
FCC
-
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1 – THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE.
CAUTION: Risk of explosion if the battery is replaced by an incorrect type. -
THIS DEVICE MUST ACCEPT INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
WARNING: The batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
MODEL: P5. FCC ID: 2AGNC-P5. IC: 20967-P5.
FCC WARNING
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s author-ity to operate the equipment. This
device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, includ-ing interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.Note: This equip-ment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that inter-ference will not occur in a particular installation. If this equip-ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the inter-ference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
FCC/ISED RADIATION EXPOSURE STATEMENT
The equipment complies with FCC/ISED RSS-102 Radiation exposure limits set
forth for uncontrolled enviroment.
REAR VIEW
CONTROLS
PAIR
Keep two units next to each other and PRESS-AND-HOLD their pairing buttons
simultane-ously until the LED flashes quickly in a red light, then release
buttons. 
Choose master unit by PRESSING ONCE on the pairing button of one unit and then
quickly PRESS TWICE on the pairing button of the slave unit
SPECIFICATIONS
- Type: Powered portable speaker
- Amplifier: Digital Class D amplifier, 10 W + 25 W
- Tweeter: 1″ dome
- Woofer: 3,2″ custom long throw
- Frequency range: 57–20.000 Hz
- Crossover frequency: 2000 Hz
- Dimensions HxWxD: 97x220x53 mm
- Inputs: Bluetooth 5.0 (TWS*) + Aux In 3,5 mm stereo
- *plays audio on two devices at once.
- Power consumption: STB / ON: <0.5 W / 1,9 W
- Charging: USB-C 5V DC (4 hours to fully charge)
- IP: IPX4
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL
IMPORTANT SAFETY INSTRUCTIONS
-
Read these instructions.
-
Keep these instructions.
-
Heed all warnings.
-
Follow all instructions.
-
Operating temperature (˚C) 5–40
-
Do not block any ventilation openings. Install in accordance with the manufacturer’s instruc-tions.
-
The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.
-
Do not install near any heat sources such as ra-diators, heat registers, stoves, or other product (including amplifiers) that produce heat.
-
Protect the charging cable from being walked on or pinched at the point where they exit from the product.
-
Only use attachments/accessories specified by the manufacturer.
-
Unplug this product during lightning storms or when unused for long periods of time.
-
Refer all servicing to qualified service personnel. Servicing is required when the product has been damaged in any way, such as charging cable is damaged, liquid has been spilled or objects have fallen into the product, does not operate normally, or has been dropped.
-
Damage Requiring Service
Unplug the product from the charging cable and refer servicing to qualified service person-nel under thee following conditions:- A. When the charging cable is damaged,
- B. If liquid has been spilled, or objects have fallen into the product,
- C. If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to its normal operation,
- D. If the product has been dropped or damaged in any way, and
- E. When the product exhibits a distinct change in performance this indicates a need for servi-ce.
-
Object and Liquid Entry Never push objects of any kind into the product through openings as they may touch dangerous voltage points or short-out parts that could result in a fire or electric shock. No naked fla-me sources such as lighted candles etc., should never be placed on the product.
-
Batteries
Always consider the environmental issues and follow local regulations when disposing of batteries.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>