JAMARA 460647 Ride on Mercedes-AMG Kids Car Instructions

: June 3, 2024
: JAMARA

Table of Contents

JAMARA 460647 Ride on Mercedes-AMG Kids Car
Instruction
Suitable for children over 3 years.
Functions
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

JAMARA 460647 Ride on Mercedes-AMG Kids Car

Instruction

JAMARA-460647-Ride-on-Mercedes-AMG-Kids-Car-2

General information
JAMARA e.K. is not liable for any damage caused to the product itself or through this, provided this is due to improper operation or handling errors. The Customer alone bears the full responsibility for the proper use and handling, including without limitation, the assembly, the charging process, the use and choice of the operation area. Please refer to the operating and user instructions, it contains important information and warnings.

Suitable for children over 3 years.

Warning: Not suitable for children under 36 months. RISK OF SUFFOCATION!
Contains small parts which can be swallowed. Keep away necessarily from children
Due to its top speed this toy is not suitable for children under 3 years!

Before playing, remove all protective films from all parts
This product is not intended for use by individuals (including children) with reduced physical, sensory or mental capabilities or lack of experience and / or knowledge.
Depending on development, a minimum age of 4 years could be appropriate
Maximum weight: < 25 kg

Before assembly

Adult required for assembly. Keep children away while assembling.
Tools (not included) needed for assembly: screwdriver.

DANGER
For safe driving, you should make sure that your Child understand and adheres to the following rules:

Always sit tight, do not get up during the ride.
Never take additional Children for a ride. (The vehicle is only suitable for 1 person)
Hold tight.
Never drive without shoes.
Never drive in the dark.
To be used with protective equipment.
Keep hands, hair, loose clothing and any other item away from any rotating parts.
The Model should not be used in rooms or halls with high humidity, in the rain or on wet surfaces. Risk of malfunction or damage to electronics and housing.
The model is not water- or splash-proof. Only operate on asphalted surfaces (such as paving stones). The model is not suitable to be operated in grass or loose soil.

Mounting the wheels
Front wheels
Start by mounting the front wheels. Slide a washer onto the front axle and fit a wheel. Be careful not to confuse the front and rear wheels. Inserting a washer from the outside and secured with a clip. Mount the other wheel in the same way.
Rear wheels
Put the rear wheel on the rear axle. From the outside a washer is put on and secured with a clip. Mount the other wheel in the same way. Press the wheel covers onto the front and rear wheels.
Mounting the steering wheel
First connect the plug on the dashboard cable to the black plug protruding from the front of the chassis interior. Connect the cable in the steering wheel to the cable in the steering column. Then slide the steering wheel (4) onto the handlebar and tighten it. The hole position is fixed by a nut.
Mounting the doors
Fit the car doors by aligning them with the recesses and hinges in the bodywork. Then secure the doors with 2 screws
Mounting the windshield
Move the windshield to the intended position. Drücken Sie die Zapfen in die
Nuten, bis sie einrasten.
. Mounting the rear-view mirrors
Press the rearview mirrors into the intended positions on the car doors until they click into place
Battery connection
Connect all connectors as shown. Only connect plug connections that fit into each other and take care not to reverse polarity. Make sure that the red cable (plus) and the black cable
(minus) are connected to the respective connectors of the same colour. Switch on the vehicle by pressing the red button on the right side of the dashboard..
Mounting the seat
Insert the two pins at the rear end of the seat into the holes provided for this purpose.
Take two of the enclosed screws and fix the seat with them.
Charging
The power swich must be turned in OFF position when charging.
Insert the charger (13) into the socket – the LED lights up green. Connect the charger to the charging socket.
The LED on your charger lights up red as long as the battery is being charged. If the LED lights green again, the battery is fully charged.
The charge time is 9 hours.
Do not charge the battery more than once within 24 hours.
Charger and battery heat up during the charging process.

Warning!

The charger is not a toy. Only use the charger supplied.
The battery may only be charged by or under the supervision of an adult.
The terminals must not be short-circuited.
The charger must be checked regularly for damage to the cable, plug, housing and other parts. If any damage is found, the charger must not be used until the damage has been repaired.
Let the model cool off sufficiently after each use before putting it back into operation. When using an additional batteries let it cool off for minimum 15 minutes until the model is operated again. Overheating can damage the electronics or may result in fire.
Always disconnect the model from the charger immediately after charging. Always disconnect the charger from the power supply immediately after disconnecting the model. Inserting the rechargeable model or charger after charging will result in damage tothe model, charger or the power supply (fire hazard).
Use the charger only in dry rooms.

Functions

Soundboard
- USB
- Micro SD
- Line in
  After inserting a Micro SD card or USB stick, the soundboard starts playing the tracks one after the other. Only files with the extension .mp3 can be played back. It is not possible to fast-forward or rewind.
Voltage display
Attention!
Your vehicle displays the total voltage of the two batteries in volts immediately after switching on.
The fully charged batteries will usually display a total voltage of approx. 12.6-13 volts unloaded.
The display is load dependent. This means that the displayed voltage will drop under load. If a voltage of less than approx. 11.8V is displayed in the unloaded state, you should switch off
the Ride-on and charge the battery (see charging procedure). Otherwise the battery may be deeply discharged and irretrievably damaged.
Simulated dashboard
Speed
High speed – Fast speed Low speed – Slow speed IMPORTANT! The vehicle must be stationary before changing direction or speed. Otherwise the gear unit and/or the motor could be damaged.
Important operating information:
In 1st gear the engine power is reduced and the rear wheels can turn at different speeds depending on the load. This allows slower driving and, above all, a small turning circle. This also means that in first gear, when starting off, or when driving over a small obstacle on one side, the loaded wheel can stop and the driving force is transferred to the unloaded wheel. In order to achieve full engine power and to distribute the driving force evenly over both wheels, it is necessary to shift into 2nd gear. Attention! In 2nd gear not only the speed increases but also a larger turning circle is achieved.
ON/Off switch
With the ON / OFF switch you start the vehicle. (Soft-start and soft-stop function)
2WD / 4WD switch Switch from 2-wheel to all-wheel drive
Light button
Shift Lever
Forward: Press the “Forward-backward switch” on the “Forward” position.
Press the “Foot pedal”, the model drives forward.
Reverse: Press the “Forward-backward switch” on the “Backward” position.
Press the “Foot pedal”, the model drives backward.

IMPORTANT!
Always stop vehicle when changing the direction to avoid damage the gears and motor. Otherwise the gear unit and/or the motor could be damaged.

Problem	Source	Solution
The battery can no longer be charged	Carger or battery defective.	Check

charger and battery
The battery can no longer be charged although the battery and charger are OK.| Charging socket defective| Check or replace the charging socket.
The journey time is very short.| The battery has been deep discharged or is worn out.| Use a new battery and avoid deep discharge.
No function| Battery is not or incorrectly connected.| Connect the battery (see instructions)
ON/OFF switch defective.| Check or replace switch.
Can be switched on but does not drive.| Motor cable incorrectly connected or not connected.| Check and connect motor cable (see instructions).
Can be switched on but does notmove, or only direction.| Gas or direction switch defective.| Check or replace switch.
Can be switched on but only travels in one direction| Directional switch defective.| Check or replace switch.
The active fuse blows and switches the unit off for a few seconds. You will hear a single click at the beginning| Oberload or electrical short circuit.| Do not overload or have the until checked.
No sound function on the steering wheel/andlebar| the cable was torn or crushed during assembly.| Check or replace the steering wheel.
Vehicle has very high wear on switches.| Dirt and moisture damage the switches.| Do not drive in moisture or dirt such as meadows, gavel, sand, etc.
The rubber tyres come loose on the wheels| Ridden on too hot a surface or in dirt.| Change tyres and avoid hot surfaces and dirt.