PHILIPS PPM2522 Eye Mask Massager User Guide
- June 24, 2024
- Philips
Table of Contents
Eye Mask Massager
Vibration Eye Mask Massenger
PPM2522
Quick Start Guide
PPM2522 Eye Mask Massager
-
Remove the contact enses, frame glasses or accessories around your eyes.
-
Adjust the elastic headband and wear the product comfortably on your eyes.
-
Press and hold the power function button for 2 seconds to power on the deviceand there s a voice prompt of “Massage on”.
-
After power-on, the default mode s [Eye Beauty Mode], its built-in music is enabled by default, the multi-frequency vibration+ the warm compress in the medium level is enabled, and you will hear the voice prompt “Eye Beauty Mode”.
-
0ne second later, as the voice prompt of “Search for the new Bluetooth device” sounds, it switches back to the built-in music of the device. During the use of the product, the user can enter the Bluetooth music mode by pairing the device in the electronic devices.
-
Click the power function button to switch the massage modes in the sequence as follows: Eye Beauty Mode, Eye Care Mode, Energizing Mode, Sleep-aid Mode, and Eye Warming Mode.
-
Toggle the power function button upward once to switch the temperature levels in the sequence as follows: Medium- High – Low. The initial temperature level of each mode shall be subject to the actual definition, and the levels should be switched in turn according to the sequence.
-
Toggle the power function button upward twice to turn off the warm compress with the voice prompt of “Turn off heating”. Toggle the button upward twice again, the warm compress will restart with the voice prompt of “Turn on heating”.
-
Toggle the power function button downward once to switch to the music playlist.
-
Toggle the power function button downward twice to turn off the music with the voice prompt of “Turn off music”. Toggle the button downward twice again, the music will restart with the voice prompt of “Turn on music”.
-
Bluetooth name: Philips PPM2522
a.If the electronic device is connected to the Bluetooth of this product successfully, there will be a voice prompt of “The Bluetooth device is connected successfully”.
b.lf the connection fails, there will be a voice prompt of “The Bluetooth device fails to connect”, and then t will be switched back to the built-in music automatically. -
It s recommendedtostartata low evel when using the massagerforthefirsttime, soas to avoid rr tation.
-
Close your eyes dur ng use of the product. Blurred vision may occur when you take off the product after use. Just close your eyes for 1 to 3 minutes, and this condit on can be eased.
-
After use, clean the surface of the product with a damp cloth or an alcohol pad. Do not rinse it directly w th water.
Visit us
www.philips.com
There may be certain differences between the content of this manual and your
product, Please refer to the actual product. We reserve the right to update
the product at any time without prior notice.
©2023 AquaShield
Allrights reserved
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke
Philips N.V, and are used under license,
This product has been manufactured by and is sold under the responsibility of
Guangdong Deerma Technology Company Limited and Guangdong Deerma Technology
Company Limited is the warrantor in relation to this product.
RevA MAR 23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>