T G TG659 Portable Speaker User Manual
- June 22, 2024
- T G
Table of Contents
T G TG659 Portable Speaker
Product specifications:
- BT: 5.3
- Working distance: 10M
- SNR: ≥85db
- Battery:3.7V 500mAh
- Normal volume playing time: 1H
- Speaker driver : Ø 52 mm
- Power : 4Ω/5W
- Frequency response: 120 Hz-18KHz
- Unit size:90.3mm90.3mm53.5mm
- Unit weight:218g
- Charging:5V/500mA
Product Feature:
- International advanced wireless chip and circuit design techniques, support all wireless devices.
- With Hi-Fi speaker, to make sure the clear and bright sound.
- The wireless working distance is 10 meters, can connect all out wireless devices (cell phone/ Tablect PC/ TV) to play music.
- Support Micro SD card and USB card, play MP3 format audio.
- With FM function, can search radio station broadcast automatically.
- Built-in Mic for handsfree call.
- support TWS
key & slot function:
- DC 5V slot: Use the standard TYPE-C USB charging cable for power charging.
- TF slot: It can decode and play MP3/WAV format audio when put TF card into the slot.
- USB slot: It can decode and play MP3/WAV format audio when put the USB card into the slot.
- Power switch: long press for “on/off ”. when play music (USB card/ TF card/FM/ BT), press short to switch USB/TF/FM/ BT.
- When play music(USB card/TF card/BT), press short for “play/pause”. under BT mode with mobile paired, when coming call, press short to answer a call, press again to hand up.(in FM mode, press short to search station automatically, press again to stop searching); Keep the TWS speaker under BT mode without pairing, press the “play/pause” key for 4 seconds either of the speaker until hear a hint and meantime the button light stop flashing, now is in TWS mode, then can paire the mobile.
- When play music, Press short for last song, long press to turn down the volume.
- When play music, press short for next song, long press to turn up the volume.
NOTE : In the FM mode, put in the charging cable to get better FM radio station.
Warning statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>