VG TECHNOLOGY VGSNCH1 Color Change Control Box User Guide
- June 12, 2024
- VG TECHNOLOGY
Table of Contents
VGSNCH1 Color Change Control Box
Getting Started
- Read all enclosed Safety Instructions and cord tags before starting.
- Plug your tree light into a power source.
Using the Control-Box
Functions
Press the Function button on the controller box to switch between the following light effect modes.
- Steady white
- Steady multi
- Steady red
- Steady green
- Steady blue
- Color Changing White to Multi
- Color Changing Red to Green
- Color Changing White to Blue
- Color Changing All 5 colors
- Off
Press the “Function” button on the control box in order to set your desired lighting function.
- You can press any control box within range (50 feet) of your other lights in order to control the lights wirelessly. Press the function button, all your lights will change functions automatically – as long as they are on the same Channel.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>