Generic 2BDO7S13 3 In 1 Wireless Charger User Manual
- June 22, 2024
- Generic
Table of Contents
Generic 2BDO7S13 3 In 1 Wireless Charger
Device Layout:
Product Parameter
- Product name: 3 in 1 wireless charger
- Material quality: ABS + Silicone
- Dimensions: 24774.57.SMM
- Interface: USB-C
- Input: 9V-2A,12V-2A
- Mobile phone output: 5W/7.5W/10W/15W
- iWatch output: 2.5W
- Airpods: 3W
- Compatibility: support mobile phones, Airpods, and
- iWatch that comply with the Qi standard
Steps for usage
The device is connected to the power supply through the charging cable, and then it can be powered on. When charging the mobile phone, place the mobile phone flat in the mobile phone charging area to start charging the mobile phone. After fully charged, simply take off the phone, during the charging process, if you need to terminate the charging, take it directly.
When charging the Apple Watch, place the iWatch flat in the charging area to start charging the watch. After fully charged, directly remove the iWatch; During the charging process, if you need to terminate the charging, remove the iWatch directly.
When charging the Airpods, place the Airpods flat in the charging area to
start charging:
After fully charged, simply remove the Airpods; During the charging process,
if you need to terminate the charging, remove it directly.
Special Note: When charging the iwatch, recommended to use flat and vertical charging at 90 degrees. Do not select 30 degrees, as charging may not be possible at this angle..Recommended to use the supplied charging cable for power supply, and not to use the original iphone cable.
Packaging accessories
- 3 in 1 wireless charging *1
- USB-C charging cable *1
- Manual *1
- Packing box *1
The content of this manual and product specifications are subject to change without notice.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- To maintain compliance with FCC’s RF Exposure guidelines, This equipment should be installed and operated with minimum 20cm distance between the radiator and your body:
- Use only the supplied antenna.