ZEBRA MN-004845-01EN Verifone Payment Z Back for ET5x Installation Guide

June 21, 2024
ZEBRA

ZEBRA logo Verifone Payment Z Back for ET5x
Installation GuideZEBRA MN 004845 01EN Verifone Payment Z Back for
ET5x

Installation

CAUTION: Power off the ET5x before installing or removing the Payment Z Back.
CAUTION: Do not use any tool for battery cover removal.
Puncturing the battery or seal may cause a hazardous condition and a potential risk of injury.
Remove the battery cover and store in a safe place.

MN-004845-01EN Verifone Payment Z Back for ET5x

Using a plier, remove the two gaskets.

Align the payment Z back to the battery well.

Using a cross head or Phillips screwdriver, secure the payment Z back to the device using three M2 11 mm and two M2 4 mm screws. Place the payment device into the bottom tray. Align the top cover with the top locking mechanism, and lock it in place.

Press down the top cover to clip it in place.

Using a cross head or Phillips screwdriver, secure the payment device using four M1.6 5 mm screws.

Insert the payment device into the Z back.

Swipe a card with the magnetic stripe facing the tablet.

Insert a card with the chip facing away from the tablet.

To remove the payment device, press the release latch and slide the payment device out of the Z back.

Zebra Technologies | 3 Overlook Point | Lincolnshire, IL 60069 USA
www.zebra.com
ZEBRA and the stylized Zebra head are trademarks of Zebra
Technologies Corp., registered in many jurisdictions worldwide.
All other trademarks are the property of their respective owners.
© 2023 Zebra Technologies Corp. and/or its affiliates. All rights reserved.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals